1 Answer Hello Sunny. Make sure the freezer is between 0° and 5°. You need to check and see if there is power going to the water valve when the icemaker cycles. If so, replace the water valve on the unit. If not, or the icemaker does not cycle, you will need to replace the icemaker on the unit. Also, check and make sure the fill tube on the unit is not frozen and clogged. If so, replace the water valve and thaw out the fill tube. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Lee July 14, 2016 for Model Number RF28HMEDBSR/AA-0002 Ice is building up and blocking the hole where the air blows out above the icemaker. I unplugged the refrigerator and blew hot air into it and melted all the ice about 3 weeks ago and now the ice is built up again and blocking the air flow. What could be causing this problem?
1 Answer Hello Lee, This is going to be an air leak. This is most commonly found around the freezer door seal to cause the ice chute to freeze. Read More...
Jerry June 05, 2016 for Model Number RF263BEAESR/AA-0000 My icemaker makes ice but will not dispense it unless I hit the reset button. would I be able to replace the control board or do I need to replace the entire unit?
1 Answer Hello Jerry. You will need to replace the icemaker in the unit if the temp is correct on the unit. Read More...
Colleen May 24, 2016 for Model Number RF263BEAESR/AA-0000 Can you tell me if part number DA97-15217A and DA97-12317A are inter changeable. Thanks
1 Answer Colleen, According to the manufacturer the DA97-15217D is a direct replacement part for the DA97-12317A. Read More...
Tim May 12, 2016 for Model Number RF32FMQDBSR/AA-0000 Is this replacement ice-maker (DA97-15217A) any less prone to freezing and seizing than the original ice maker (DA97-15217A)? Hope so, but suspicious now about Samsung's engineers.
1 Answer Hello Tim. Sorry, we do not have any information from the manufacturer on the icemaker design. Read More...
Wayne January 01, 2016 for Model Number RF263BEAESR/AA-0000 My ice maker keeps freezing up. I thawed it out by putting cups of hot water in side the ice maker, that worked three or four times. Now the ice maker doesn't make ice at all. What is the problem ?
1 Answer Hello Wayne, This sounds like a compound problem involving both the icemaker DA97-15217D and the water valve DA82-02869A. Read More...
Rob January 20, 2015 for Model Number RF31FMESBSR/ Following your suggestions and some online YouTube video demonstrations, I have the Ice maker forward about one inch and it is very loose in the compartment, moves up and down but will not come out. It feels like something is connected to the back and not letting loose. Do I use brute force?
1 Answer Hello Rob, If you have a copy of the service manual, the icemaker removal begins on page 48. If not, we could send you a copy if you could provide a valid e-mail address. It basically states: When pressing the Energy-Saver and the Fridge buttons on the Display together for 8 seconds at the same time, it will convert to the Test Mode and the entire Display function will be off. When pressing any button within 15 seconds after it is shifted to the Test Mode, its function will change in the following order. Manual operation 1 (FF) Manual operation 2 (0F-r) ? manual defrost of fresh food compartments (rd) ? manual defrost of fresh and freezer compartments (fd) ? cancel (Display all off). ? Set unit to Fd for 5 minutes. This will allow for easy removal of the ice maker. While pressing the tab on the top right side, lift up the Ice Bucket and pull it out. Remove the screw from the Wire Housing Cover. Remove the Wire Housing Cover. Disconnect the Ice Maker Housing Connector. Disconnect the Ice Maker Housing Connector. Remove the screw from the Duct Tray-ice. With a flat blade screwdriver, push the duct to the right and remove it from the locking tab. With a flat blade screwdriver, pry down on the refrigerant tube to separate it from the bottom of the ice maker. Push down the refrigerant pipe slightly and separate the refrigerant pipe and the Ice Maker Assembly completely. While pressing the Hook, pull out the Ice Maker. While pushing down the Duct-Tray-Ice, pull out the Ice Maker carefully and remove it. ? When removing the ice maker, be careful not to damage the grommets on the tray or the refrigerant tube. Read More...