Dar June 09, 2022 for Model Number Dw80r506oug Keeps blinking Lc cannot clear it shut breaker off unplugged it wiped everything off still when I plug it in it blinks lc
1 Answer Dar, This code indicates that there is a water leak that is most likely underneath the unit. Check for leaks into the pan at the bottom of the unit, check seals, valve, anything that can leak on the unit. Read More...
William May 04, 2021 for Model Number DW80K5050US I am getting an "lc" code and the dishwasher keeps running to drain, but there isn't any water I am told by Samsung that it is the leak sensor and to leave the door open and let it dry I have done that and after a week it happened again What part do I need to replace and is there a YouTube showing how? Tks
1 Answer William, the dishwasher would need to be checked for any leaks that could be occurring. Another item that would need to be inspected is the overflow float in the front left of the dishwasher. If there is any debris under the float, or if it is stuck in the upward position, it can cause this failure. Read More...
April April 27, 2020 for Model Number DW80K7050US Hi, I need to replace the leak sensor on my Samsung dishwasher model DW80K7050US. Want to make sure this is the correct one to order?
Ken A. April 15, 2018 for Model Number DW80J3020UB/AA The dishwasher does not fully cycle. Stops about 10 minutes into cycle and the "HEAVY" and "AUTO" lights begin flashing. I also noticed, once, that the drain pump kept running when I opened the door. I never noticed any water standing in lower part of dishwasher when the lights started blinking. I tried power cycling with circuit breaker to cancel error, no success. By playing around with it trying different cycles I got it to work for one batch of dishes....then back to same problem. What sensor or part has or is failing and how do I get to it. Is part available from Appliance Parts Pro?
1 Answer Ken, For this issue the error would be a over level water error. This will most likely be a faulty water supply valve. Read More...
Jimmie January 30, 2017 for Model Number DW80F800UWS/AA Keep getting error code oE; turned off breaker and blew out lines with air compressor; turned on breaker, worked at first and then stopped during cycle; the grinder will still work at times with the door open. Is there a way to check the sensor; if not, which one; also, could I disconnect the water valve and check conductivity, if not which one. Would you try the sensor first?
1 Answer Jimmie, This issue would most likely be caused by the case brake assembly which will have the sensors in it. The case brake assembly will be DD82-01373A. Read More...
Buck January 16, 2017 for Model Number DW7933LRAWW/AA-0001 Samsung dishwasher has error code flashing: Heavy and Smart Auto lights.
1 Answer Hello Buck, This is the over-level water error code. Parts that can cause this include the flow meter DD94-01006A, main PBA DD92-00033A, and the water inlet valve DD62-00084A. Read More...
1 Answer Hello John. Make sure to disconnect the power & water supply & drain hose connections. Remove the upper & lower baskets in the dishwasher. Pull out the dishwasher carefully. . Lay down the dishwasher on its back. Release the two(2) screws fixing the base and shutter in place. . Pull out the shutter and release the leakage sensor connector. . Remove the leakage sensor from the shutter by unfastening the two(2) screws. Read More...