Vinny December 26, 2022 for Model Number RB195BSBB Can I replace part DA41-00264A without unplugging the refrigerator?
1 Answer No repairs should be completed without unplugging the appliance. This is especially important for electronic parts as plugging in can cause a surge and damage. Not to mention the risk of death from electrocution. Read More...
George October 30, 2019 for Model Number rb215lash when I turn on icemaker freezer drops to 25 below 0
1 Answer George, this is most likely caused by the user interface causing the unit to go into a power freeze mode. If the compressor operates for 2½ hours after turning the ice maker on, then this would be the case and the user control DA41-00264A would be the most likely cause as it would be sending improper signal voltage to the main control. Read More...
Randy September 17, 2018 for Model Number RB195BSVQ The power in my area recently was off for about 5 hours. After this event, my ice maker no longer makes ice. The display on the front of the refrigerator is set to make ice, but nothing happens. I can manually make ice by pushing the black button on the ice maker, but after that the ice maker does not automatically make ice. The display on the front of the refrigerator has been slowly fading over the last few years. If the display goes bad can that be my problem even if it says to make ice? What should I look at to diagnose this problem?
1 Answer Randy, It sounds like you have 2 different issues one being that it sounds like the icemaker is faulty but the display dimming would be the second issue and will need a display control. Read More...
John Stolz July 05, 2018 for Model Number RB215LASH What is the difference between parts #'s: AP4139222 & AP4139131 They both look exactly like the Interactive Display for my Samsung fridge. Thanks. John
1 Answer John, They may look the same, but they aren't the same The DA41-00264A / DA41-00264A is the correct display board for the model number you supplied. The DA41-00264D / DA41-00264D display has different circuitry, is used for a export model refrigerator, and is not interchangeable. Read More...
Ray K. April 05, 2018 for Model Number RB195BSSB The freezer is working fine. The refrigerator compartment is freezing the food. The temperature on the display reads 48°F but it is much colder in the refrigerator compartment. The display set point is 46°F. Are the sensors in the refrigerator bad or could the problem be the display or main board found in the compressor compartment? Thanks
1 Answer Hello Ray, This can be a bad thermistor DA32-10105T or a bad main control DA41-00293A. Read More...
Ed R March 17, 2017 for Model Number Rb215lapb Good morning having issues with my freezer maintaining temps. Set at -2 but bounces around to 18 to 20 back down to 5 won't hold consistent temp. Did reset on display board which also not lighting all the numbers. Now I did swap my door to the other side and moved the switch also. My upper refrigerator section is holding temps with no issue. Thinking of replacing the display. Board. Any input would be greatly appreciated. Thanks Ed
1 Answer Ed R, The display not lighting all the numbers would indicate a bad display board unless any of them are flashing which would be an error code. As for the other issue of freezer temp will check the sensors in the freezer and if they check ok then would be an issue with the main control board. Read More...
Jay November 12, 2016 for Model Number RB195BSBB The control panel display on the front of our Samsung fridge is not showing numbers, only a couple of dashes. If the food is not on the bottom of the freezer, the food does not freeze thoroughly and the fridge seems to freeze food fine. Eggs, things on the top shelf freeze.We are not able to adjust the control panel with the buttons. Looked at the back of the panel, no burnt spots or loose solder connections. Just an easy replace the panel problem?
1 Answer Jay, Based on the issue that you are having it sounds like this issue would be caused by a faulty main control board. Even though there may not be a solder joint that is weak a component on the board could have failed and wound need a new board. Read More...
Ronnie September 14, 2016 for Model Number RB195BSBB I just replaced the main board an the thermal fuse. The thermal fuse was shorted out . When I took it apart to find the problem . The front panel was working fine. Now it's not only has two straight lines flickering on the freezer side display. The refrig and freezer are working ok.
1 Answer Ronnie, You will want to check the connections at the main board to ensure that they all have a good connection. Also look at the original board and there will be a number on it. Check to see if the board matches the one installed. This would be the most likely cause of a mismatched board. Read More...
Jeremy Cooper July 25, 2016 for Model Number Samsung RB195BSSW Problem may be two-fold. Firstly, the display panel is on the fritz and only displays partial numbers. I assume I need a new panel for this. The second issue is that the freezer temp seems fine (no thawing foods) but the fridge department seems to either be cooling intermittently or set to too high of a temperature (I've noticed the milk spoils easily). I'm thinking with a control panel I can read, I'll know if there's a secondary issue. Should I start with the just control panel or does it sound like something else? Thanks.
1 Answer Jeremy, It would be best to go ahead and change the control panel but in the mean time would suggest checking the unit for a possible defrost issue or a sensor that may have be bad. Read More...
Marty G. May 02, 2016 for Model Number RB215BSSB The temperature seems to be colder than the temperature on the control board. I have attempted to change the temperature but it doesn't seem to do anything. The ice maker also stopped working with the power surge. Is this a temperature sensor or circuit board? Thank you
1 Answer Hello Marty, This is more likely to be caused by the control board DA41-00293A. Read More...