Dave July 15, 2016 for Model Number RF32FNQDBSR My samsung fridge freezes just fine (bottom of fridge is working)...but the top of the fridge doesn't seem to cool and temperature stays at 58 degrees. I purchased and replaced all 3 boards..still doesn't work..what else do you recommend i replace?
1 Answer Hello Dave. Check for a defrost issue in the fresh food section and make sure the evaporator fan motor is good in the fresh food section. Thanks. Read More...
Rich June 12, 2016 for Model Number RF261BEAESR/AA-0001 Fridge does not cool. No codes come up. Service man told me Control Board is shot. Any way to test this? Possible alternate problem? 2 year old Samsung Bottom freezer w/Side by side fridge.
1 Answer Hello Rich. You can test for power from the board to the compressor. If it is not there, then the board is bad. Read More...
Donny June 02, 2016 for Model Number RF263BEAESR/AA-0000 My fridge has built up ice in back panel, the freezer on the bottom drawer does not freeze, the display shown inaccurate temperature and no error code shown. Do you have any clue whats going on? Help...
1 Answer Hello Donny. It sounds like you may have a defrost problem with the unit. Check and see if there is any frost build up on the evaporator coils in the freezer and fresh food. If so, you will need to test the defrost heater and the defrost thermostat and fuse. They should read closed for continuity when cold. You can test this with a multi-meter TJMA-DMT3. I will include a link at the end to assist you how to use the multi-meter if needed. If all parts are good, you will need to replace the main board. Once the problem is repaired, you will need to thaw out the ice on the coils before the unit will operate properly. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Al April 06, 2016 for Model Number RH22H9010SR/AA-0000 Our ice maker was working fine up until we had a power outage. When the power went back on, our ice maker will no longer make ice. We have made sure the ice maker itself is on and have hit the reset button several times. The arm moves up and down very slowly and the water does partially fill the tray. We also cleared the ice tray and bin to maker sure there was nothing preventing the ice from being made. We are still getting water and the freezer and fridge cooling seems to be working fine. Any suggestions on how to proceed troubleshooting? It is, of course, just one month out of warranty!
1 Answer Al, With the icemaker getting some water into it then it is calling for water. If it is not ejecting the ice then the issue will most likely be that the heater on the icemaker has failed or the control board is defective. Read More...
Eddie October 24, 2015 for Model Number RF268ABPN/XAA-0000 Hi, I recently purchased a part from you and can't seem to located where it belongs.
1 Answer Eddie, The relay protector DA34-00004D would go on the side of the compressor. If you have a solid combo relay overload combo then in order to install this part you would need to get the relay also. Read More...