John December 26, 2011 for Model Number Dacor ECS127SBK What is correct part number for lower heating element. The lower heating element does not heat, tried bake at 350 for 3 minutes did not glow red, tried broil for 3 minutes upper heating element did glow red.
John December 01, 2011 for Model Number CPD230 Is part# AP3160603 the correct element replacement for Model # CPD230? Does it just plug into the wires in the back of the oven like the one I am trying to replace?
1 Answer Hello John. Yes, DE81-03841A is the correct bake element and should install the same as the old element. Hope this helps. Read More...
Jeanne October 05, 2011 for Model Number JKP06002CF I need to replace the bake heating element on the above listed model wall oven. What part number do I need to order? The serial # of the oven is MA658708G
1 Answer Hello Jeanne. Based on the model number you provided, WB44X200 is the correct bake element. Hope this helps. Read More...
Sheldon September 05, 2011 for Model Number W305 This is an old oven, 1990 I think. I do not have a parts lists and need a new bake element. Is this the correct part for my model?
1 Answer Hello Sheldon! Yes, the bake element part number DE81-03841A is the correct bake element used on your Dacor oven model W305. This is for 240v applications. Thanks. Read More...
James M. July 07, 2011 for Model Number CPS 2305 Double electric/single convection 30" I noticed the part description has "This is a hard wire in type element and replaces the discontinued plug in type element by eliminating the terminal block". Anything I need to know about removing the terminal block and modifying for the hard wire? Thanks. Jim Read more: http://www.appliancepartspros.com/Appliance-Parts/dacor-element-item-number-ap3160603.aspx#ixzz1RSUo7wPP http://www.appliancepartspros.com
1 Answer James, Other than making sure you have the power to the oven "OFF" at the breaker box. and working slowly and carefully, don't loose the wires back into the cavity behind the oven, or "yank" on the wires, so they break. Otherwise you'll do fine. Thanks and Good Luck. Read More...
George F. May 27, 2011 for Model Number Dacor CPS130 The bake element needs to be replaced on my wall oven. I believe the part number is 86745. Can you confirm that and I understand that I will need to remove 2 screws, slide the element in place and replace the screws. Am I correct?
1 Answer Hello George! Your bake element is part number DE81-03841A. You will need to unplug the range. Remove the oven racks. In the back of the electric range, there are two screws that hold on a bake element. Remove these two screws and gently pull the element towards the door opening. Remove the wires from the bake element one at a time. You may need to use long nosed pliers to remove the wires. Be careful that the wiring doesn't fall back through the back of the oven. Once the wires have been removed, discard the old element and replace it with the new one. Once the new element is installed, plug the unit back in and test. Hope this information helps! Read More...
Susan May 16, 2011 for Model Number Dacor ersd30 I need to replace the baking element. Any advice you could give would be appreciated. The replacement part number is DE81-03841A.
1 Answer Hello Susan. You should be able to just shut the power off to the stove. Remove the screws retaining the current element, pull it out and slide off the old connectors and simply slide them onto the new element and screw the retaining plate back in. I hope this helps Read More...