Scott February 09, 2024 for Model Number front loading whirlpool washer the horizontal drum seems to have a larger gap between the drum and the rubber piece i just replaced going around the whole hole and sealing the door shut. looks like this rubber piece should also be going around one more ridge on the inside closest to the spinning drum but the video posted says nothing about it. any thoughts? i can take pics but no place to post them.. thank you
1 Answer Scott, if the model number of your appliance could be provided in a new question, this will allow the most accurate information to be presented. Read More...
Rob November 03, 2023 for Model Number MHW3505FW1 I installed the below seal. Instruction video was great. The door is a bit harder to close now that the new seal is installed. Everything looks correct, it's seated properly etc. Just wondering if this is expected?
1 Answer Rob, a new bellow can be a little rigid and need a little firmer of a push to close the door. This is a normal occurrence as the seal forms to the door. Read More...
Hope June 14, 2022 for Model Number WFW92HEFCO What bellow (seal or gasket?) do we need to replace our current part. The previous owners obviously did not take care of this washer and the whole thing is moldy and I cannot get it out. So need to replace it.
Shalini May 25, 2021 for Model Number Whirlpool WFW94HEXW2 hi, is part AP6238143 (bellow) compatible for washer model Whirlpool WFW94HEXW2? Thanks
Bob February 27, 2021 for Model Number WFW95HEDWO I have this washer mdl. WFW95HEDWO, I need the Bellow seal, is the part no. W11106747 for this model?
Charlie April 11, 2020 for Model Number WFW95HEDCO I'm looking for a replacement door boot - is this the correct part for my WFW95HEDCO W11106747 Thank you
Johanna January 31, 2020 for Model Number WFW6620HCO I am looking for a replacement bellow for my washing machine. I can't find the part number. Any suggestions
1 Answer Hello Johanna, the bellow for the model number supplied is part number W11314648. Thanks! Read More...
Adi September 03, 2019 for Model Number MHW4300DW0 Can you provide a list of the tools needed for the job? I did see it in the video, but it will be useful to have a reference written list.
1 Answer Hello Adi, tools as follows, a Philips screwdriver, Torx tip #20 screwdriver, 1/4" hex head nut driver, flat screwdriver. Read More...
Sharon March 08, 2018 for Model Number MHW4300DW0 Do you have a video to watch on how to replace the bellow?
1 Answer Sharon, Unfortunately there is not a video for this bellow but in order to get the bellow off you would need to remove the main top of the unit and there will be screws on the back of the control panel. Remove the control panel and then remove the screws holding the front panel on and you will be able to get the door boot installed. Read More...
1 Answer Hello Sandy, I'm sorry but this door seal W11106747 does not include the clamps. They will have to be ordered separately. Read More...