Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Refrigerator Electronic Control Board by Whirlpool

Best Seller
Manufacturer Part
4.89 (64)
By: Whirlpool
Part Number: OEM18057696
Manufacturer Part Number: WPW10310240

Refrigerator not cooling or control panel blank? This electronic control board manages temperature, defrost cycles, and compressor operation. DIY repair.

More
$271.60

IN STOCK
Ships Tomorrow Guaranteed
Add to Cart

Questions & Answers

For Whirlpool Refrigerator Electronic Control Board (Part Number: OEM18057696)

1 Answer

Hello Bob. Check under the drawers in the bottom of the refrigerator and make sure nothing is blocking the air return tunnels. Also check and make sure the damper inside the icemaker is not leaking into the refrigerator around the gasket, and the ice bucket is seated and locked in place allowing a good seal around it as well. If all of these check good, here are some test to perform. If all of the test are good, replace the H.V. Board. Hope this helps.
Service Test Mode:
The service test functions are performed using the refrigerator display and keypad. Enter the Service Test Mode by performing the following sequence of events:
1. Press and hold the Door Alarm Keypad.
2. Press and hold Refrigerator Temperature Up Keypad .
3. Release the Door Alarm Keypad and wait 3 seconds.
4. The Freezer display will display SE confirming entry in the Service Mode.
5. Press the Refrigerator Up Keypad again to confirm entry in the Service Mode.
6. Display will show 101 in left display and numeric or dashes in right display.
7. Press Freezer Up Keypad and Freezer Down Keypad to toggle through Service Test numbers.
Run the following test procedures.
Service Test – 121 Damper Operation
• Press the Refrigerator Up keypad and Down keypad to toggle Damper (OP) open and (CL) closed.
NOTE: If damper is opening or closing it will not allow you to toggle damper and beep. Display will show state –CL or –OP if Damper is in the process of closing or opening.
Service Test – 141 Fresh Food Thermistor
• Will Show Fresh Food Temperature or OP for open thermistor or SH for shorted thermistor.
Service Test – 145 Ice Box Thermistor
• Will Show Ice BoxTemperature or, OP open thermistor or SH shorted thermistor.

Read More...

1 Answer

Hello Bob. You will need to test and see if the damper WPW10127427 is opening and closing on it's own. You can test this by turning off the refrigerator. When you turn it off, the damper should close, and when you turn it on, it should open. If it is not doing this, you will need to test and see if there is power coming to the damper assembly. If there is power there, but the unit is not working, you will need to replace the damper. If there is no power there, then the H.V. Board could be bad. Hope this helps.

Read More...

1 Answer

Hello Bob. Yes, if the damper stays open, the food in the refrigerator will freeze. If the temperature inside the refrigerator is 33 and the temperature on the door reads 46, the thermister 12002355 is bad and will need to be replaced. That should fix the damper as well. Hope this helps.

Read More...

1 Answer

Hello Bob. You will need to test the thermister 12002355 and make sure it is good. Here is a chart to go by when testing it. You can test this with a multi-meter MA-DM1. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html
Thermistor
Temperature Resistance
77°F..................10,000 ohms
36°F..................29,500 ohms
0°F....................86,300 ohms

Read More...

1 Answer

Hello Fred. It is located on the back of the refrigerator. There is a metal cover over it, held on with screws. Hope this helps.

Read More...

1 Answer

Hello Stephen. You will need to check the damper assembly and make sure it is not stuck open. WPW10127427 If it is, you will need to replace it. Hope this helps.

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google