Don February 09, 2014 for Model Number MFI2269vem11 Ice maker not working. No water in the cube maker tray. Water is available at the dispenser. What do you think the problem might be?
1 Answer Hello Don. Make sure the freezer is between 0° and 5°. You need to check and see if there is power going to the water valve when the icemaker cycles. If so, replace the water valve on the unit. If not, or the icemaker does not cycle, you will need to replace the icemaker on the unit. Also, check and make sure the fill tube on the unit is not frozen and clogged. If so, replace the water valve and thaw out the fill tube. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Ted December 08, 2013 for Model Number MFI2569YEM0 My Maytag Refrigerator Dispenser Front Panel has No display and lights (LED's) means total blackout. The inside light bulbs are okay when you open the door and turns off when yo closed the doors. Lastly, I don't hear the compressor running or inside nopt getting cold. Getting info from internet that the Electronic board is the suspect. In my case, what do you think the problem? Can you please help me . Thanks
1 Answer Hello Ted. If there is no power to the dispenser board, you will replace the main board WPW10312695. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Vince October 17, 2013 for Model Number MFI2569YEM0 I am having defrost problems with my freezer, it will not defrost on its normal cycle. I replaced the thermostat and the problem persists. I can force the defrost cycle and I can feel the heater coil get warm. Ice is building up on the coils and back wall of the freezer So, i think the control unit is bad, do I change this part? and are there instructions included for the removal and installation? Thank you
1 Answer Hello Vince. If it works on force defrost, you will need to replace the control board in the unit. Read More...