Steve February 11, 2019 for Model Number mgr5875qds The oven won't turn on, the button won't beep when pressed. However, the gas control part is fine. Does this sound like a clock control issue?
1 Answer Hello Steve, This does sound like an issue with the control WP74008629. If the button does not cause the beep, it is the probable cause of the issue and since it is part of the control, the control will have to be changed to correct the issue. Read More...
Shannonmarcano@Yahoo.Com April 22, 2013 for Model Number Maytag Gas Range Oven will not heat to full temperature and seems to shut off. When unplugged and plugged back in, the code F-14 shows on the digital display. Burners and broiler are working fine. What could the problem be?
1 Answer shannonmarcano@yahoo.com,To properly assist you we will need your model number to help you with this. Please post your model number with a new question on the parts page. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
1 Answer Rob, If the igniter WP7432P136-60 stays on, even after you cancel a cycle, Then the clock/ERC WP74008629 would be the place to start. You could have a stuck relay, but you should have an error code in the display. If the igniter glows when you start a cycle, and shuts off when you cancel the cycle, then you'll need to check the amp draw of the igniter with an ammeter, to see that it draws at least 3.2 to 3.6 amps. and check the oven safety valve 12002604 and wiring for a shorted bi metal switch in the valve, or shorted wire to chassis ground completing the circuit and causing the igniter to stay on. Read More...
Bob January 05, 2013 for Model Number mgr5875qdw My oven no longer turns on. After I unplugged it it came up with a F-14 code. I think the control board is toast. Wondering if this is the correct control board and if it comes in white to match my stove.
1 Answer Hello Bob, The part number you need to order for a white control is WP5701M640-60. Read More...
Greg November 28, 2012 for Model Number mgr5875qds My Maytag oven starts beeping when it's been on between 30 minutes and an hour. Then at some point it shuts off and certain control buttons stop working. They eventually start working again once the oven cools off. I got on live chat and the person there told me it could be a burnt relay in the clock component. Does that sound to you like the issue or could it be something else? Two other points: 1. I just replaced the heat sensor that came in the mail from you guys today and that did not do the trick 2. There are no error codes appearing when this happens Thanks for your help
1 Answer Hello Greg, Based on the information provided it sounds like the the clock WP74008629 is defective and needs to be replaced. Read More...