Moe W April 01, 2012 for Model Number MAH6700AWW how do you open the pannel to replace the main control board
1 Answer Moe, Here's some help : "Top Removal 1. Disconnect power supply to unit. 2. Remove 2 10mm screws from washer back. 3. Slide Top Cover towards the rear to clear the screw head from flange on the bottom side of the Top Cover. Dispenser Removal 1. Disconnect power supply to unit. 2. Depress the release tab and slide drawer from washer. 3. Remove clamps and hoses from dispenser. NOTE: The hose circuitry is marked on the Dispenser top. 4. Remove attachment screws and lift dipenser to expose fill hose. 5. Remove fill hose clamp and hose. Console Removal 1. Disconnect power supply to unit. 2. Remove Top Cover. 3. Remove Dispenser Drawer. 4. Remove five screws attaching Console.5. Roll Console down and lift away from washer. 6. Remove Reactor wire harness from wire clip. 7. Remove Reactor wire harness connector from the PCB Board. 8. Remove five screws from PCB Housing to access the LED Circuit Board." Thanks and Good Luck Read More...
Sue March 31, 2012 for Model Number MAH6700AWW You asked for the serial number in regards to my last question, serial number is 11746006GX.
1 Answer Sue, according to your model/serial number the electronic control is part number 34001479. Thanks! Read More...
Sue March 31, 2012 for Model Number MAH6700AWW We had someone come out and take a look at our washer because a code kept coming up for a control knob malfunction. The repairman said that it needed to have the main control board replaced. Is this the correct board?
1 Answer Sue, the elec-cntrl WPW10273828 is the electronic board. However, there is a series changed issued on the boards for this model and we will need your appliance serial number to verify if this board is the correct one used on your appliance. Thanks! Read More...