Customer Questions and Answers for Electronic Control Board by Whirlpool

Moe, Here's some help : "Top Removal 1. Disconnect power supply to unit. 2. Remove 2 10mm screws from washer back. 3. Slide Top Cover towards the rear to clear the screw head from flange on the bottom side of the Top Cover. Dispenser Removal 1. Disconnect power supply to unit. 2. Depress the release tab and slide drawer from washer. 3. Remove clamps and hoses from dispenser. NOTE: The hose circuitry is marked on the Dispenser top. 4. Remove attachment screws and lift dipenser to expose fill hose. 5. Remove fill hose clamp and hose. Console Removal 1. Disconnect power supply to unit. 2. Remove Top Cover. 3. Remove Dispenser Drawer. 4. Remove five screws attaching Console.5. Roll Console down and lift away from washer. 6. Remove Reactor wire harness from wire clip. 7. Remove Reactor wire harness connector from the PCB Board. 8. Remove five screws from PCB Housing to access the LED Circuit Board." Thanks and Good Luck