Chester N. October 10, 2011 for Model Number MDBH968AWS3 I have replaced the door latch recently and still do not have power to the unit. 1 or 2 lights came on but pushing the start button or any other does not start the machine. Before I order a new control board (W10169322) do you have any other ideas? Yes I have positive 110V at the machine. This machine is only 2 yrs old, and only 1 person lives in the house so it does not get alot of use. Also you have answered a previous question about the white ribbon going to the control board but what about the other end to the front panel, that does not look like it comes off?
1 Answer Hello Chester. Based on the information you provided, it sounds like the control panel WPW10235721 is bad and will need to be replaced. Hope this helps. Read More...
Chet September 04, 2011 for Model Number maytag dishwasher Replacing part # W10169322 ( control board ), does the ribbon tape come off, and how do you remove it?
1 Answer Hello Chet. Yes, you will need to remove the ribbon cable from the control board. The white connector the cable is seated in, slide forward to release the cable, then insert the cable into the new control board WPW10226297 and pull the connector back to lock the cable into place. Hope this helps. Read More...
Gary F. June 06, 2011 for Model Number mdbh968aws3 How do I install the control panel and are there installation instructions with the part? Part no. is ap4411301. Thanks
1 Answer Hello Gary. First disconnect the power going to the dishwasher. You will need to remove the screws holding the inner door panel in place, and remove the inner door panel. Then you will need to remove the cover off the control board housing. Once removed, you can access the control board. Remove the wires going to the control board, and the ribbon cable. Then unsnap the control board out of the housing and reinstall in reverse order with the new control board. Hope this helps. Read More...