Skip to Content
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Trusted Since 1999 Trusted Since 1999
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google

Customer Questions and Answers for Electronic Control Board (Central Control Unit) by Whirlpool

Best Seller
Manufacturer Part
4.89 (64)
By: Whirlpool
Part Number: OEM18066783
Manufacturer Part Number: WPW10491312

This electronic control module is the appliance's main brain, coordinating cycle timing and sending power to pumps, motors, valves, and heating elements. Replacing a failed board restores reliable operation and resolves erratic or non-start issues.

  • Manages cycle sequencing based on user settings and sensor inputs
  • Distributes power to key components to execute each step of the cycle
  • Common symptoms of failure: won't start, won't advance/complete cycles, or stops mid-cycle
  • Also causes intermittent operation or fault/error codes
Includes: 1 electronic control board Install notes:
  • Disconnect power at the breaker before servicing; use proper ESD precautions
  • Location varies by model
  • Photograph wiring and move connectors one at a time to the new board
  • Secure the board, reassemble panels, restore power, and run a test cycle

More
$248.24

IN STOCK
Ships Tomorrow Guaranteed
Add to Cart

Questions & Answers

For Whirlpool Electronic Control Board (Central Control Unit) (Part Number: OEM18066783)

1 Answer

Hello Harlan. If the water temperature sensor (NTC) value is out of range (23°F to 217°F
[-5°C to 103°C]) during the water-heating step of the WASH cycle. Possible Causes/Procedure - Unplug washer or disconnect power.
- Make sure that connections to water heater & CCU (TH2 & HE2 cavities)
connectors are not broken or with wires detached, and that connector internal
pins are visible.
- Check continuity from the water heater sensor (black wires) to CCU
(TH2 cavity) connector.
- If the continuity diagnosis failed, the Main Harness must be replaced.
- Check the resistance of heating element.
- Check the resistance of the water sensor.
- Plug in washer or reconnect power.
- Verify the washer operation by running the Diagnostic Test cycle.
- After the diagnostic test has finished, unplug washer or disconnect
power and wait for 15 seconds.

Read More...

Have questions? Ask our pros!

Contact us in a way that is convenient for you

Call us 1-877-477-7278
Need Help? Chat with a Pro
Or ask a question by filling in the form

Share your thoughts with other customers

Ask a Question
  • 5,000+ Repair Videos 5,000+ Repair Videos
  • Same-Day Shipping Same-Day Shipping
  • 365 Day Return Policy! 365 Day Return Policy!
  • Repair ForumFree Tech Support!
  • Top Quality Store on Google