Peter November 21, 2013 for Model Number kuds30ixbl1 I started a cycles last night. everything went well. This morning the cancl/drain and control lock were blinking. The dishes were clean what could be the cause?
1 Answer Hello Peter. Check and see if the control panel is locked on the unit. If it is not locked, then you will need to replace the control board on the unit. Read More...
Peter November 11, 2013 for Model Number KUDS30IXBL1 A month or so ago we lost the light on the sani rinse selection. Everthing else worked. Last night the beeper sound stopped working. All of the lights still work except the sani rinse. Is this a touch pad issue or control panel.
1 Answer Hello Peter. Beep is part of a control board and the control panel is the issue with the light on the unit. So you may need both parts. Read More...
Woody November 10, 2013 for Model Number kuds301vbt2 Dishwasher is working, but when complete washing cycle is done. Light flashes on the key pad, If you hit cancel its starts the rinse cycle.
1 Answer Woody, Based on the information provided it sounds like either there is a bad control panel or a connection issue with corrosion on the ribbon cable. Read More...
Greg November 08, 2013 for Model Number KUDS35FXSS0 Dishwasher control panel won't function, no buttons light up or function, tried power reset, no go. Last night while still non-funtional, I closed the door and it did a "drain" cycle, I could hear the pump running. This AM, nothing.
1 Answer Hello Greg. It sounds liek the thermal fuse W10402110 is bad and will need to be replaced on the unit. Read More...
Dave September 01, 2013 for Model Number kuds3oixbl1 I know that there is a reset on the main logic board but can you please tell me where in detail. I know that this my problem but l am at a loss do to the rough schematics that came with the dishwasher.
1 Answer Dave, There is not a reset on the control board of this unit. To reset the control you would disconnect the power to the unit for 30 minutes and then reapply the power to restart. Read More...
Craig May 08, 2013 for Model Number KUDS30CXSS0 Hello, My Kitchenaid KUDS30CXSS0 has developed problems. the control lock light is always on faintly. Has developed a tendency to stop and not complete cycles. The unit has gotten louder with a with a med level pitch whine when pumping water. Any ideas are appreciated, I can swap parts with the best of them. Thanks!
1 Answer Hello Craig, This sounds like the either a poor electrical connection or the board is going into failure. First check the wire nuts behind the kick panel inside the electrical connection box. Next, clean the ribbon cable with a pencil eraser, rubbing the eraser only toward the end of the ribbon cable to prevent damage to it. If these don't help, the control WPW10380685 is the next step. Read More...
Bob S. June 20, 2012 for Model Number Kuds301xbl0 My heavy duty,pro scrub and start resume leds are on real faint. The washer will start,run for awhile then stop. Is that the control board?
1 Answer Hello Bob. If some of the selections are not working, and the lights are not working, it may need the control panel WPW10500174. If the unit is loosing power, then the control board WPW10380685 may be bad and will need to be replaced on the unit. Read More...