Deana March 18, 2011 for Model Number gvw9959kq2 My washer fills up but wont drain, and it has the code either ld or ob. I just want to make sure it is the pump. Please if you can help me. Is it easy to replace.
2 Answers Hello Deana! Here is the information from our failure code link:LD failure code: Means Long drain: "Ld" flashes if it takes longer than 5 minutes to pump out water to a point where the operating pressure switch resets. Press STOP/CANCEL to clear the display.Make sure that nothing is restricting the drain hoses or drain pump from draining properly.OB failure code: Means Off Balance: If the motor controller detects an unrecoverable off-balance condition, the machine controller will shut down and display an "ob" for off balance. The lid switch must be opened at least once before restarting the cycle, if this condition occurs. Opening the lid will allow you to view and redistribute the load. Press STOP/CANCEL to clear the display.Make sure that the washer is not being overloading and the clotes are being distrubted evenly.Hope this information helps! Read More...
Guest March 15, 2011 for Model Number 11021086000 Kenmore elite washer, can I buy just the pump without the motor?
1 Answer Hello! It seems that the pump and motor now come only available as a complete assembly from the manufacturer. The part number is 285990. Sorry! Read More...
Guest March 13, 2011 for Model Number gvw9959kt2 Suddenly, the washer has started leaking, noticed when it hit the rinse cycle. New pump was replaced in 2005 and had been working ok. It does finish the cycle and pump seems to be working ok, since it's not leaving any water or wet clothes. Please advise on how to find the source of the problem.
1 Answer Hello. You will need to remove the bottom plate on the washer to look for leaks. Hope this helps. Read More...