Jim December 28, 2012 for Model Number ACF3375A Hi, The stove right front does not spark if the right front knob is turned, but it still does spark if the right rear knob is turned. Is it more likely the ignitor, or is the issue more e likey in the knob somewhere? Thanks.
1 Answer Hello Jim. The spark switch on the unit is bad. The spark switch has been permanently discontinued by the manufacturer and we don't know of any source or replacement for the part. Read More...
Brett December 11, 2012 for Model Number Amana ARG7300LL Gas Range/Oven Hi, All 4 of the burners have stopped sparking, making it necessary to light the burners with a match. Do I need to replace all four ignitors, or is there another component, such as a central spark generator/module that controls all 4 ignitors that I actually need to replace instead of the ignitors? Thanks in advance!
1 Answer Good thinking Brett, since all four burners aren't sparking, it could be that you need a new spark module 32020101. Thanks! Read More...
Bob August 05, 2012 for Model Number ARG57650SS All for burners justed stopped sparking. Is there a spark module part number that has to be replaced? Can it be replaced from the top?
1 Answer Hello Bob! The spark module is part number 32020101. The spark module will include step by step installation instructions. Thanks! Read More...
Cookingwithgas July 22, 2012 for Model Number ARGS7650E All burners ignite quickly except the right front which does spark but does not light the gas. Cap and other parts are clean and properly installed. Do I only need to replace the igniter for the one burner now working properly?
1 Answer Hello Cooki, If the ignitor spark is blue or almost white, there is no need to replace it. The burner will be the issue. If the spark is orange or red, as long as you have cleaned the area and checked for proper grounds, the ignitor will need replacement. Remember the gas has to get out at the ignitor for the spark to ignite it, therefore, the burner may be your issue. Read More...
1 Answer Dan, You're sure the burner bases and igniters are clean, and the burner caps are installed on the burner bases properly. Make sure you're power cord is plugged into a polarized grounded 120 VAC outlet. If thats all OK, you'd have a weak spark module 32020101. Good Luck and Thanks Read More...
Bill July 02, 2011 for Model Number ACF3355ac To replace the top igniter, do I have to remove the burners, then the stovetop, or can I access the burner from the rear?
1 Answer Hello Bill. You can remove the burner caps. Then remove the two screws holding the burners in place. Lift the burners and unplug the wire going to the igniter WPY0316773. Reinstall in reverse order. Hope this helps. Read More...
Don February 25, 2011 My Amana stove top AKS3040 or AKS3020 not sure which one it is but I bet they use the same ignitor. This says made by Whirlpool,,,is this going to work, it looks the same as the one I have in my hand,,, Thanks for your help
1 Answer Hello Don. Both the model numbers provided use this electrode. The Amana name brand is owned by Whirlpool now. Thanks! Read More...