Dave September 20, 2022 for Model Number WOD51ECOASO1 The lower unit overshoots the set point by 40-50 degrees. Then drops back to the set point. But open the door and close it and the temperature drops by 30 degrees and holds that for a period of time but in time does slowly climbs back to the set point
1 Answer Dave, the temperature sensor WP74008369 would need to be tested for resistance after the oven power supply has been turned off. It should read around 1080 to 1100 Ohms at room temperature and when heated up with a hair dryer, should increase by 2 Ohms of resistance for every 1°F that it raises in temperature. If the sensor tests good, the broil element WPW10260252 would need to be tested for 114.7 to 16.8 Ohms and the bake element W11545804 tested for 19 to 21.6 Ohms. If the elements and the sensor tested good, the most likely cause of failure would be the oven relay control W10803217. Read More...
Jeffery March 03, 2022 for Model Number JMW2430DS03 JENNAIR MICRO/OVEN COMBO BUILT IN Hello, Neither my broil nor my bake elements are heating up. I smelled something strange a day or 2 prior to this occurring. I attempted to check the continuity of the broiler element and it appears not to have continuity. If the broil element is out will it cause the bake element or a total shut down of the entire oven? How do you access the bake element to test that for continuity? Is there another part that may be the root cause of this total malfunction? Thank you
1 Answer Hello Jeffery, You can check the broil element by checking for continuity from the blue wire on terminal 2 of the K11 relay to the red wire with a white trace on terminal 2 of the K3 relay. It should be noted that both the bake and broil elements get L2 from the K3 relay which is considered a double line break relay. It is fed through the temperatire limiter WP4449751 located on the back of the unit. If it shows continuity, the board W11179310 will need to be replaced. Read More...
Max C. December 03, 2021 for Model Number WOD93EC0AS00 Whirlpool double electric oven. The top takes over 30 min to reach temperature. Bottom less than 15 min. Is this most likely the bake element or temp sensor or a thermostat problem? Thanks
1 Answer Hello Max, The first thing to check is the oven sensor WP74008369. The oven sensor should have a resistance of 1090 ohms at 77 degrees and would add 2 ohms for every 1 degree of temperature increase. If this tests good you should then make sure the high limit thermostat WP4449751 shows continuity. If this is good, the board W10550511 will be the issue. Read More...