1 Answer Hello Noah, You are correct. WP8203528 is the correct surface element for the front left on the model you provided. Read More...
Vince July 08, 2012 for Model Number GR399LXGQ What should the ohm reading be on the limter and on the element for the front left burner?
1 Answer Hi Vince. The limiters will read closed (.01 -.5 ohms.). Put together the meter leads as you have the meter scale set on R x 1. What the resistance on the leads will normally read in this range. This is subtracted from the measurement you have if you need to be specific. The element resistance is ohms. Disconnect the 1a and the 1b wire. Then on the center terminal to the one that had the red wire on it you will read between 35-65 ohms. Reconnect the red wire and disconnect the orange wire. Test between the center terminal and the orange wire terminal, the meter should read between 25-55 ohms. 9" element is part # WP8203528. Thank You. Read More...
Kyle November 23, 2011 for Model Number kerc507ywh1 Please look at the second of two pictures you have provided above for this part. Pay particular attention to the connectors. The original part for my model (OEM part # 9750755) has been discontinued, and the part above is now being provided by Whirlpool as a direct replacement. The problem I am having is this: the connectors for the direct replacement part a situated differently than the original, and I am unsure about how to install the new part. Here are two pictures of my original part: http://bit.ly/rvS3p4 and http://bit.ly/uYdjnO As you can see, the connections, although similar in some ways, are clearly different. If you could help, I would appreciate it. Also, if you could provide me a wiring diagram, that would be extremely helpful. Thank you.
1 Answer Hello Kyle. You will plug the purple and the black wires on the back of the block in the same location as the original element. Then take the black wire, not the jumper, and plug it into the last spade on the side of the new element. Then the other black wire, goes to the terminal on the block under the purple wire. If wired this way, the element WP8203528 should work properly. Hope this helps. Read More...
Kyle November 21, 2011 for Model Number kerc507ywh1 I ordered this part from you, left front burner. And the wiring is a bit different than your replacement burner, please advise.
1 Answer Hello Kyle. You will plug the purple and the black wires on the back of the block in the same location as the original element. Then take the black wire, not the jumper, and plug it into the last spade on the side of the new element. Then the other black wire, goes to the terminal on the block under the purple wire. If wired this way, the element AP3182986 should work properly. Thank You. Read More...
Nichole May 09, 2011 for Model Number WDP86802 What is the correct element part number I need? Its the front left burner. I need a replacement and I cant find this model number anywhere.
1 Answer Hello Nichole. The model number you provided is not working. Can you check and make sure you have the correct model number? Thanks. Read More...
Packrat May 06, 2011 I need a element for a whirlpool designer style glass top stove but the part number they gave me is coming up to the right burner but the glass tubing is different . Does this matte? Mine is long, it goes from one side to the other where the new ones just have it as half the element does this make a difference? Everything else is the same just this glass tubing that is inserted into the side and goes right accross on my old burner element can you help me?
1 Answer Hello! We will need your appliance model number to verify part numbers. Thanks. Read More...