Russ L. May 25, 2018 for Model Number WTW7600XW2 My Whirlpool Cabrio lid started making popping noises and didn't want to close or open fully. Do I need to replace the LH/RH Lid Hinges and Lid Hinge Arm? Are there springs that might need to be replaced, too? How do I do this myself?
1 Answer Hello Russ, You will need to order two WP8563964, WPW10309357 for the left spring assembly, and WPW10309358 for the right spring assembly. Remove the screws from the sides of the lid hinges and use a putty knife to raise the main top to access these spring holders. You will have the job completed in about 20 to 30 minutes. Read More...
1 Answer Jim, Unfortunately there would not be a video for changing the lid springs on the unit. To gain access to them you would remove 2 screws on the back of the unit and slide the main top forward. Once you slide it forward you can lift up on the main top. Read More...
Ken June 16, 2017 for Model Number Hinge-lid AP6004795 Can you use this hinge on either side of the washer or is there a left hinge and right hinge configuration difference?
1 Answer Hello Ken, If you look at the part description you will see the initials "LH". This normally denotes that the part is for the left hand side only. I'm sorry but we will need to ask you to post a new question including the model number from your units' I.D. tag so we can recommend parts that can be guaranteed to work properly on your unit. Thank you for your patience and understanding in this matter. Read More...