Darrell F. September 21, 2011 for Model Number mzd2665heq What tool do you recommend to peal off the facade insert without scratching the facade, than how do you connect the wires to the new insert?
1 Answer Hello Darrell. You can use an ice pick to raise the edge and peel it off. There are no wires to connect on the insert WP67004151. It is a sticker that covers the buttons. Hope this helps. Read More...
Darrell F. September 21, 2011 for Model Number mzd2665heq What do you use to pry off the facade insert after you have removed the two screws behind the drip tray?
1 Answer Hello Darrell. You do not need to remove the facade screws to replace the insert [AP4079284. You can peal the insert off the facade. Hope this helps. Read More...
1 Answer Hello John. 1. Remove drip tray by pulling it straight out from door. 2. Remove two hex screws at the bottom of facade that were hidden by drip tray. 3. Push down on facade to release retainer clips. 4. Remove facade WP67004151 and disconnect ten pin connector from control board. 5. Reverse procedure to reassemble. Hope this helps. Read More...
Denny H May 19, 2011 for Model Number Maytag MSD 2651HEB How is this facade installed? Thank You, Denny H
1 Answer Hello Denny! To install this part, first, unplug the fridge. Remove the overflow tray and remove the two hex screws. After those have been removed you should be able to unscrew the electronics board and remove the facade. Reverse the instructions to reinstall it and you should be all set. I hope this info helps! Read More...