Brian Norton June 02, 2013 for Model Number kudc03fvss0 The dishwasher has power, top control light will light up. The problem is when you push the start resume button it will flash instead of going solid green light. The machine will not start. Tried disconnecting power to reset. This did not work.
1 Answer Brian, You most likely have a faulty pause resume keypad on the control board WPW10084134 . You may also have a faulty door switch or loose wire connection at thee switches. Read More...
Rich January 30, 2012 for Model Number kudk03ctwh2 Stops in mid cycle,resume light flashes as if the door was opened,but it wasn't. If I push the door inward hard and then push the resume button,it starts back up. Based on other questions on your site it seems I may have a latch problem. What steps do I need to do to replace part #AP3996721. Is it on the top of the door itself or is it the part on the top of the dishwasher where the door pushes against? This problem is very intermittent. Some days it works just fine. Does the unit build up pressure while washing and cause the door to expand outward enough to deactivate the switch assembly?
1 Answer Hello Rich. The door latch WPW10404412 is not hard to replace. You will disconnect the power and remove the inner door panel on the unit to access and replace the latch assembly. Hope this helps. Read More...
Don September 10, 2011 for Model Number Kenmore dishwasher 665.13123K703 How do I check the for fault codes? My unit stops during the wash cycle and then the "start and resume" light flashes as if the door had been open (it has not) I think the latch is defective. Any ideas or comments?
1 Answer Don, The door switch assembly and wiring is a great place to start, you also want to consider a new door latch strike as well [W10077370] Good Luck and Thanks Read More...
Ken September 06, 2011 Put new door latch part no W10077360 still start will not work it is getting power.
1 Answer Hi Ken. We will require the exact model # you have so we can be specific with needed info. Is there any fault codes? Is the motor humming like the chopper blade is jammed? Is the water in the tub? Check the float and fill switch if not. Thank you. Read More...
Ruben July 13, 2011 for Model Number kude03ftss1 The door does not close completely and can't start the cycle. In the door you can see the piece is broken. Which piece do I need to make it close?
1 Answer Hello Ruben. Based on the information you provided, it sounds like the latch assembly WPW10404412 is bad and will need to be replaced. Hope this helps. Read More...
Jay June 20, 2011 for Model Number KUDS03FTPA3 Is there a way to verify the manufacturers part # with your part # so I can be sure I am getting the right one? Mnft # w-100 77360 your part # AP3996721
1 Answer Hello Jay. For the model number provided the correct latch is WPW10404412. To answer your question, yes we can cross reference manufacturer part numbers. It shows to be the same, thanks! Read More...
Jay June 20, 2011 for Model Number KUDS03FTPA3 The door will not latch. I think this has to do with the plastic latch in the door being weak or broken but I notice it is hooked to electrical components. Is it possibly an electrical problem? Most likely what is the problem?
1 Answer Hello Jay. If the door does not latch properly and the strike WPW10317686 is not broke, you will need to replace the door latch assembly WPW10404412. Hope this helps. Read More...