George September 13, 2011 for Model Number wtw6200sw3 Just got a lid switch assamble (part # ap3891130) for whirlpool auto washer cabrio (model # wtw6200sw3) from you . Can you please email me a detail instruction of how to get to it and replace it? Thanks for all you help .
1 Answer Hello George. To remove the lid lock:a) Raise the cabinet topb) Remove the two hex-head screws fromthe lid lock and remove the lock.c) Cut the indicated cable standoff fromthe cabinet top.d) Unclip the lid lock cable from the cabinettop flange.e) Disconnect the lid lock cable connectorfrom the machine/motor control connectorat P12.f) Pull the end of the lid lock cable fromthe control, and remove the lid lock andcable assembly from the washer.Reinstall with the new latch WPW10619844 in reverse order. Hope this helps. Read More...
Scott September 05, 2011 for Model Number AP3891130 I was wondering if there was a detailed schematic of part #:AP3891130. Thanks
Les S. July 20, 2011 for Model Number 11027087604 Last 2 digits off will this fit my model (ap3891130)
1 Answer Hi Les, yes the latch part # WPW10619844 fits the model number you provided. Thanks! Read More...
1 Answer Hello Nicole. You will need to remove the screws holding the latch in place. Then remove the console off the machine by unscrewing the three screws in the back and pulling the console forward and lifting off. Unplug the cable from the console to the board. Then raise the top of the machine by releasing the clips under the front corners. Remove the wires for the lid switch from the board and the frame of the machine. Reinstall in reverse order with the new lid switch. Hope this helps. Read More...
Nicole E. May 24, 2011 I dont have my model number with me right now but I just got the new latch for my whirlpool cabrio and it didnt have instruction can you please help me with that?
Cate May 23, 2011 for Model Number mvwb750wq1 I wondered if it was easy to install a new latch on this machine. How would I get to it to replace it?
1 Answer Hello Cate. To replace this part you will simply need to pop the top frame off to reveal the locking mechanism. Remove the screws holding the lock in place, and unplug the old one, and install the new one in its place. I hope this info helps. Read More...
David G. April 26, 2011 for Model Number WTW6200SW3 I ordered a new latch assembly for my top loader Cabrio wtw6200sw3. I have no idea how to access the wiring within the compartment to replace it. Any guides available. Am I better of hiring a pro?
1 Answer Hello David! I have located a wiring diagram that may be of some assistance in installing the parts needed. If you can reply back with your e-mail address in the question body section (we will not post this) we will be glad to send a copy. Thanks! Read More...