Jeremy April 29, 2019 for Model Number KFIS25XVMS9 Prior to my unit breaking the door was sometimes hot. And the light got stuck on. The day after my light was temporarily stuck, my refrigerator wasn’t working at all. I changed the main board and only the fan runs asking to be set with the code on the inside. I go through the process but don’t see any way to enter #s. I also see that the light gets stuck on. Could this be the dispenser board? Is there any way to check it. The part is more expensive than the main board.
1 Answer Jeremy,if the dispenser keypad is not responding correctly to enter the code for the new rear main control board then the keypad is faulty, however the manufacturer has discontinued the keypad as well as the dispenser control board. Read More...
Ck January 04, 2018 for Model Number KFIS25XVMS1 Hi i replaced the main motherboard in the back but am having problems coding in the front control board. Do i need another part for this?
1 Answer CK, No, normally you do not need additional parts when replacing the Hi Vac control board on the back of the refrigerator. Make sure you have the correct board for the model/serial number of the refrigerator WPW10310240 / W10213583 Board, HV Control, verify the "personality" code on the model/serial tag inside the refrigerator. When programming the new control board, time is limited between the key pad presses, trying to read the instructions, and press the keypads at the same time is usually too long and the eeprom resets itself and won't accept the inputs. You need to memorize the starting steps, or have someone read them as you press the keys. Also remember, if you make a mistake, or the board doesn't accept the inputs, remove power to the refrigerator for 30 to 60 seconds, and start all over again. Read More...