Lucy May 23, 2023 for Model Number 4K45SS My mixer is only working on the low speed. When it try to adjust the speed, it will not move. What do you think I need?
1 Answer Lucy, You will want to make sure that the speed link is not binding up and check to make sure that the lever is damaged. Read More...
1 Answer Dottie, There is a specific way that the link will go into place and the flat part of the plastic piece on the end will face down. Read More...
Doughboy May 23, 2023 for Model Number 5KSM125SER4 When I adjust the speed there are only two speeds. Extra fast or slow. Would this efffect the speed settings?
1 Answer Doughboy, This speed link could be an issue but it would be more likely a phase board or a speed control plate that is faulty. Read More...
Hal February 26, 2020 for Model Number K5SS mixer The new one piece plastic link-speed part binds on the flat spring. Is it still used? The old one had a nylon part of the end..
Michael Noonan June 05, 2017 for Model Number 5KSM150PSEER4 (European 240volt version) My Kitchenaid Artisan Mixer, Model No. 5KSM150PSEER4 (220-240 V European version) operates such that, even after what adjustment that I can make, the lowest speed setting - settings 1 - results in a mixing speed that is about twice what it should be, while top speeds, while fast, hardly vary at all beyond speed setting 6 (i.e., after speed setting 6, there is no noticable speed increase). All speed adjustments were made with no load. What is the likely cause (and remedy?). Other than that it seems to operate and sound normal. Thanking you in anticipation.
1 Answer Michael, For this issue the most likely cause will be a faulty speed control plate WPW10119326. Read More...
Jack June 14, 2014 We thought we were having an issue with the control board as our Kitchen Aide Artisan would not stay on-we replaced the control board now we get no power at all Yes there is power entering the control board just not entering the machine
1 Answer Jack, A model number would be a big assist, we would be able to check and verify our recommendation(s). Based on the information you supplied, you most likely have a malfunction in the control panel / keypad assembly. But we can't be positively sure without the model number. Thanks Read More...