Charlie August 31, 2023 for Model Number 110.28922790 Hello, Need to replace the upper agitator dogs. Removed the dust cap, but there is no bolt present to remove. Is there a special tool required to remove the upper agitator center portion which has (4) rectangular notches 90 degrees apart? I can send an image for reference if you can provide an address. Thank you.
1 Answer Hello Charlie, check for a retainer stud in place of the new style hold down bolt, it is plastic and should unscrew using a 1/2 " drive extension shaft as the tool, here is a link showing a similar repair.https://www.youtube.com/watch?v=WOdasU9oFaE Read More...
1 Answer Arman,Your model doesn't come up as valid. But part number WP8537433 has the agitator dogs included. Read More...
Annette March 14, 2023 for Model Number Kenmore 70 Series 110.82872100 Looking for correct dogs for agitator. Thank you.
Steve April 05, 2014 for Model Number LSR8010PQ1 Our washer is about 8 years old. Sometime back my wife noticed that the agitator was spinning in one direction. She asked me if it was suppose to turn in only one direction or go back and forth. I could not remember and don't have the answer. Can you tell me if our model spins in one direction only, or two? and, if it is broken, does it need the cam kit assembly (or what) to make the appropriate repair?
1 Answer Steve, The lower portion of the agitator WP3347288 will oscillate back and forth. The agitator mover WP3348752 will rotate in one direction (counterclockwise) only. If the mover turns in both directions, then you will need the agitator repair kit 285811 Read More...
Secraven February 18, 2014 for Model Number whirlpool design 2000 I have an older washing machine and the agitator (this particular style is two parts) comes off during spin cycles. It will sometimes come loose during the wash cycle as well, especially with heavier loads of clothing. The top half of the agitator is what comes off. I took it apart and I believe the upper housing is supposed to contain a cam shaft with the dogs in it and that entire cam isn't there. I am curious as to whether buying this part will fix it or if i need to replace the entire agitator system including the base piece.
1 Answer Hello Secraven, If you could please include the model number from your units' I.D. tag, we will be able to look up the model you are dealing with and even provide you with correct part numbers. Thank you for your patience and understanding in this matter. Read More...
Bill November 17, 2013 for Model Number 110.23832100 I need a agitator repair kit for my Kenmore washer, what is your correct part number? Thanks for your help!
Lonnie October 28, 2012 for Model Number LSR8244EZ0 How do the agitator dawgs work and purpose of them.
1 Answer Hello Lonnie. They are gears inside the agitator used to drive the top section of the agitator. Read More...
Gwen H. March 20, 2012 for Model Number 110.24852300 Kenmore Is there a plastic ring or washer that goes between the two agitator parts? I just put in new agitator dogs but there is nothing between the two agitator parts to hold them together?
1 Answer Gwen, if the upper and lower agitator are not staying together, the entire agitator assembly will need to be replaced. Your part number is WP8538246. Thanks! Read More...