Customer Questions and Answers for Panel- Con by Whirlpool

Best Seller

Manufacturer Part

Panel- Con

4.89 (64)

By: Whirlpool

Part Number: OEM13093356

Manufacturer Part Number: 6-919844

Questions & Answers

For Whirlpool Panel- Con (Part Number: OEM13093356)

Robert M. April 20, 2012 for Model Number mdbtt60awb

I can not get the lock fuction off. Do I need to replace the control panel?

Hello Robert,

This is what I found in the use and care guide:
Control Lock Option

(select models)

The control touchpads can be locked to prevent

unwanted use. If this feature is activated between

cycles, the dishwasher cannot be operated until the

controls are unlocked. If desired, the controls can be

locked after a cycle or delay has started.

Setting the Control Lock:

1. Press the Heated Dry pad for three seconds.

2. An indicator light next to the lock graphic will

illuminate when the controls are locked.

To Cancel:

1. Press the

Heated Dry pad for three seconds.

2. The indicator light will go off.

If this isn't working for you, it's either going to be a bad control panel 6-919844, (a failed button), or the control board has gone into failure.

Steve T. March 03, 2012 for Model Number MDBTT60AWB3

Machine will not come on sometimes for houres at times.It isn't the lock button' tried that. It will work fine for weeks then it will do it again. I've tried unpluginng it to reset computer and that does't work either.What do you think it could be?

1 Answer

Hello Steve. Based on the information you provided, if the power is dead, but then works, you will need to replace the control board WPW10218837. If just the buttons dont work, but the lights do, then you will need to replace the control panel 6-919844. Hope this helps.

Mike February 29, 2012 for Model Number mdbtt60aww

What's the difference between control panel parts AP4364107 and AP4364449?

1 Answer

Mike, the control panel listed as part number 6-919844 is black in color and part number 6-919844 is white in color. Thanks!

Mike November 21, 2011 for Model Number mdbtt60aww

How do I install the panel control? Do I have to reset it somehow?

1 Answer

Hello Mike. You will need to disconnect the power to the unit. Then remove the screws securing the inner door panel. Remove the inner door panel and remove the cover off the control board. Remove the ribbon cable from the control board and remove the screws holding the control board housing in place. Next remove the screws holding the control panel in place. Reinstall with the new control panel 6-919844 in reverse order. Hope this helps.

Chris V. October 05, 2011

I have some buttons that work and some that don't, some intermittent. Would you suggest replacing the panel or the control board? Already tried reseating the cables.