Jerry D. March 16, 2011 for Model Number ED5FHEXNQ00 Water will not flow into icemaker. Arm will turn if started by hand, but no water fill after cycle. Could this be the water flow valve
1 Answer Hello Jerry! Make sure that the fill tube has not frozen or developed any leaks. If not, you may need a new valve part number W10408179. Hope that helps! Read More...
Tom March 15, 2011 for Model Number 10671192107 On the wiring harness (the one the ice maker attaches to, not the one from the ice maker) there is a short wire hanging. where does that attach?
Rob March 15, 2011 for Model Number MSD2433 The ice maker ejector fingers have ice build up at their ends, which prevents the ejector from continuing its cycle of ejecting the next batch of cubes (the ejector stops rotating). If I gently push the ejector fingers it will break off the ice build up and the ejector continues to rotate on its own. Also, the ice cubes produced are not fully formed. What is causing this problem? Thanks.
1 Answer Hello Rob. Check the filter and see if it is bad. If it is good, you may have a bad water valve. Hope this helps. Read More...
Patrick March 14, 2011 for Model Number 10655249400 How hard is it to take the kenmore icemaker out, and what tools do I need?
1 Answer Hello Patrick. These are not hard to remove. You will need to remove the 1/4 in hex screws holding it in place. Then unplug the wiring harness. Reinstall in reverse order. You will need a 1/4" nut driver. Hope this helps. Read More...
Guest March 13, 2011 Hello...I have a Maytag fidge model GS2614CXFO, in doing the search the models close to this were GS2614CXFQ and GS2614CXWX. The diagnostic I had was a faulty ice maker. Does the GS2614CXFQ fit the GS2614CXFO model? How much is for shipping and handling to PR?
1 Answer Hi, The model number provided is incorrect only by the last digit. The correct one will be GS2614CFXQ, and the icemaker for that unit is D7824706Q. Thanks! Read More...
Jon March 13, 2011 My Amana fridge (model afd2535deq ) freezes ice cubes, but is unable to eject them. It sounds like it's trying, but the cubes are frozen in. What do you think?
1 Answer Hello Jon. It sounds like you have a bad icemaker. The heater mold assembly is not releasing the ice. Hope this helps. Read More...
Robert March 12, 2011 for Model Number ED2FTGXKQ04 The ice maker is dripping from the bottom for several minutes after a refill. Could this be because of a defective fill valve, or should I replace the icemaker with a replacement kit?
1 Answer Hello Robert. You can check and see if the water continues to drip in from the valve through the fill tube. If so, you will need to replace the valve. Hope this helps. Read More...
Dustin March 12, 2011 Our ice maker will not fill the tray. If I swap wire plugs fountain to icemaker and hit the button it will then fill the tray with water. Everything else works with the icemaker what part needs replaced?
1 Answer Hello. It sounds like you may have a bad water valve. WPW10245167 Hope this helps. Read More...
1 Answer Hello Jim. Here is a link to our Repair Forum, this is a free service to our customers. Use this link to access the repair for your question. http://forum.appliancepartspros.com/refrigerator-freezer-repair/29618-ice-maker-not-working-kitchenaid.html Read More...