Norm July 25, 2013 for Model Number msd2732grq parts ap4076601 61005883 replacing the door chute to the bracket how do you fit the bracket to the piston on the solenoid there is a slot on the piston to fit in the bracket so the door will open & close. with the door & bracket in place the slot is at a opposite angle to the piston slot also the piston makes a humming noise some times
1 Answer Norm, We attempted to send you some illustrated information to assist you in the repair of your refrigerator. Unfortunately " Technical details of permanent failure: Google tried to deliver your message, but it was rejected by the server for the recipient domain aol.com by mailin-02.mx.aol.com. [205.188.190.1]. The error that the other server returned was: 550 5.1.1 <: Recipient address rejected: aol.com". If you still need assistance, please re post and attach a proper e mail address. Read More...
Norm July 24, 2013 for Model Number msd2732grq I am replacing the door chute aaap601005883.the bracket that holds the flap has to attach to the solenoid piston. I need to know how to attach it I tried different ways. also the piston makes a humming sound.
1 Answer Norm, To get the door bracket on the solenoid bracket. You will let the door flop all the way up. Raise the solenoid arm and slowly push the door back down while lining it up with the solenoid arm. Read More...
Bill G May 25, 2013 for Model Number Js48sedbda Recently my ice dispenser stopped working, it continued to make ice just would not come out of the door. The water still was able to be dispensed. Now the water stopped working. Now nothing works on the dispenser, not even light. Refrigerator and freezer working fine, ice is also still being made. Just can't dispense anything. Thanks Bill
1 Answer Bill, You will want to check the wiring harness at the door hinge to make sure that there are no loose or broken connections in the wiring. If this checks ok then most likely the dispenser control is faulty and needs to be replaced. Read More...
1 Answer Hi D 2. I have researched the service manuals but it is purposely not explained due to a liability issue. From experience I will try to explain. Remove power. Remove the spill catcher. It has 2- hidden screws that need to be removed. Then lift up on the fountain Eustachian control and pull off the front while unhooking the interface control board. Then you are at the fountain bracket assy. part # WP61003407. On the back side of this is where the solenoid is mounted. Pay attn. of the winding and position of the spring. It goes on one way and it is only wound once ! If you see that the bracket has melted because the solenoid was continuously on, then replace it. Remove the torx type t-20 screws. The chute inner door flapper has to completely seal against the door chute. Inspect it and replace it if needed. Part # WP61005883. Also it would be wise to replace the center strike if yours does not have the center finger. part # WP61005886. Thank You. Read More...