Kian December 28, 2014 Hello, I have been experincing intermittent delayed ignition on front right and rear left burners of the following stove: MAYTAG , NEWTON IA 50208 MODEL CRG9800CAE SERIAL 14283312QH Kindly, is the problem due to a faulty spark module or anything else? Your advice would be appreciated. Regards,
1 Answer Hello Kian. First try cleaning the burners and orifices on the unit. If they are dirty, the spark is not good and the unit will not light properly. If they are clean, then check for good gas flow. Also, make sure the igniters are not bad on the unit. Read More...
Andy September 24, 2014 for Model Number jds9860aaw parts The right front burner will not spark when any knob is turned to "ignite". All of the other burners do spark when any knob is turned to "ignite". Although last night while my wife was using a couple of the burners I was able to make it spark. I can not duplicate that this morning. Thanks, Andy
1 Answer Hello Andy. You will need to replace the spark switch WP4330739 for that burner. Read More...
Charles C August 01, 2014 for Model Number Old Maytag range top - natural gas I have good spark on two of the burners and very week spark on the other 2 if I short one of the bad one out then the other bad one works. I switched leads at the burner underneath and the problem followed the lead. So do I have a bad module or a bad lead.
1 Answer Charles, This issue of a 2 weak igniters would most likely be caused by a faulty spark module rather than the wires going to the igniters. Read More...
Ben July 14, 2014 for Model Number jds9860aaw I am wondering if spark module is located in the same place as all others on this model lower right corner of the back because i am going to be replacing it for my brother later today
1 Answer Ben, We probably missed your deadline, but Yes, the spark module is located on the back of the range in the lower rear left corner. Read More...
Js June 25, 2014 Can someone please help me find a spark igniter for a Russell Slide in cook top. Model 35-6, serial # 000803. The company went out of business years ago. I've read on blogs that the Dacor one works, but that's all the info listed. My range has very little use as it is in a vacation home, but it's certainly worth repairing. Thank you, JS
1 Answer Hello JS! Unfortunately, we do not carry parts for or have information regarding the Russell brand to verify the available parts for your unit. Sorry about that! Read More...
Frank June 16, 2014 for Model Number KGCT025 YAL-1 Need a spark module for this KitchenAid KGCT025 two burner stovetop. You show that this part is out of stock - as does everyone else. Can you recommend a (cheap) substitute? Believe this is a whirlpool part. I am based in Mexico City, and usually go downtown and simply specify a two burner, four burner or six burner module. I may have to modify terminals, but they work. I’m in the USA for the month and am about to place an order from you, but would like to include this before checkout.
1 Answer Frank, the spark module listed for your model is part number 832956. Unfortunately, this item has been discontinued with no further replacements or cross references available and our company is unaware of any other available sources. Sorry about that! Read More...
Johnnyd June 13, 2014 for Model Number maytag crg7500aaw Where is the spark module located on range crg7500aaw located?
1 Answer Hello Johnny. Pull out the unit and look on the inside of the bottom frame to access and replace the spark module. Read More...
Roger M January 13, 2014 for Model Number mgr6772bdw On my ignitor harness the firt one in the loop i know it bad because it burnt the question is will my ignitors keep clicking because of it the clicker ignitors will not shut off i tried to by pass this useing just the other three and it still igniting do i need to replace the hole harness and since im getting fire the module should still be good im ordering a new harness u think this will fix my problem hope u under stand this if would like to hear from you thank u roger
1 Answer Roger, Yes you would want to replace the Ignition switch harness for your unit to correct the issue that you are having. Read More...
Kat November 29, 2013 for Model Number mgr4410adh Day before thanksgiving my gas stove will not light no clicking noise and oven will not light as well. I can light burners manually and I can see the oven pilot on but can not light the oven. Would this a defective spark module causing this problem? Maytag mgr4410adh
1 Answer Kat, A defective spark module 12001596 would explain the no spark issue for the top burners, but not the oven. The oven pilot is a different system it's referred to as a "hot surface" igniter. Power from the ERC/Clock is applied directly to the igniter 12400035 , it glows and produces a circuit to the safety valve. Since you "can see the oven pilot on but cannot light the oven" what you're seeing is the igniter is on, but it is "weak" and cannot produce the electrical circuit to the valve to open it and ignite the gas at the oven burner. Read More...
Len October 27, 2013 for Model Number Maytag CHG9800BAE The 2 right hand igniters do not spark. The left hand ones work fine. I don't know if they went one at a time or both at once. Is this more likely to be the spark module or the burner igniters?