Customer Questions and Answers for Spinner Kit by Whirlpool

Hello Missy. Yes, you can run the dishwasher, but it will not clean the dishes properly and they will be dirty. It is best to wait until the spinner 8193983 is repaired on the unit. Hope this helps.

Richard, Yes, you will need to remove the water tube, to access the mounting tab for the upper spray arm. Two torx tip screws on the tube at the back and top of the tub, carefully disconnect the water tube from the pump accumulator(top), and remove the tube. Once removed, you will install the new spray arm and insert the locking pin and snap them together. Thanks and Good Luck

Hello Richard. You will push the spinner 8193983 onto the shaft, and insert the pin into the center to lock it into place. Hope this helps.

Hello Pame! The pin that holds the third level wash arm is a straight pin with a circle head. This pin only comes included with the third level wash arm 8193983. Thanks.

Hello Coleen. The spinner 8193983 is used to spray water on the dishes from the top of the dishwasher. If it keeps falling off, you will need to replace it for proper function. Hope this helps.

Hello Pat! the 3rd level wash spinner 8193983 comes with the pin to hold it in place. Replacing it should help. Thanks.

Hi Daniel. Yes, this will come with the spinner and nut. Thanks!