Laura April 11, 2017 for Model Number RF362LXTB1 Front left dual burner is not heating the center, just outside ring turns one. Should I change the burner?
1 Answer Laura, You will want to replace the element which will be part number WP8523047. Read More...
1 Answer Winfred, if this is a range then the model number would be located on the frame of the unit where the storage drawer is located. Read More...
Michael H. May 07, 2016 for Model Number RF377XPGN0 The large burner on my stove does not regulate the heat properly ...I have replaced the burner. Could this be caused by the block ? I have read the block needs replaced when the burner doesn't heat ...My problem is it heats too hot
1 Answer Michael, The burner and/or the block, aren't the problem. The problem is in the burner infinite control switch WP3149400 / WP3149400 (RF377PXGN0) The switch controls the power to the burner, thus the temperature of the burner. The part is in stock and available at this time. Thanks Read More...
Francine P. January 26, 2014 for Model Number RF365PXKW. Do you purchase a separate surface burner receptacle for each burner, or are there more than one in the pack? What part number do I need? I have a Whirlpool RF365PXKW.
1 Answer Francine, the burner receptacle is part number 814399. It comes one per package. If you need one for each burner you'll need to purchase four. Thanks! Read More...
Rick November 01, 2013 for Model Number RF379LXKQ When replacing the surface burner receptacle, instead of using wire nuts, can butt splices be used? The ones with the heat shrink properties?
1 Answer Hello Rick. It is best to use ceramic wire nuts due to the extreme heat, but I have seen people use the butt connectors and cover them with the heat shrink. Read More...
Hoang September 23, 2013 for Model Number rf264lxsb Why my receptacle burn out so quickly including 2 wires hook up the receptacle? about 3-4 months it burned out one...we kept very clean stove...no dripping. any help is appreciated.
1 Answer Hoang, You will want to check the unit for over voltage that would be causing the unit to burn out rapidly. This could be caused by a voltage spike in the home wiring or a voltage spike to the element. It may be necessary to replace the element, wiring and the infinite switch at the same time as a bad infinite switch could also cause this type of issue. Read More...
Alem A. December 31, 2011 for Model Number FEP320KW1 The parts on the picture are loose, do I have to assemble them by myself? Or they come assembled? Thanks.
1 Answer Hello Bhavana. We will need your model number to help you with this. Thanks. http://www.appliancepartspros.com/modelnumber_locator.aspx Read More...
Angie April 05, 2011 for Model Number RF114PXSB 1 The part I need is the surface burner receptacle diag.(9) picture on the stovetop parts. Will I need any special tools to assemble besides a screwdriver.
1 Answer Hello Angie. You will need a wire cutter and stripper. You have to splice these into the existing wire harness. Hope this helps. Read More...