Jack July 31, 2011 for Model Number GU1500XTLT2 I installed a new control panel. The diswasher ran for one wash cycle just fine, now the clean light stays on and I can't get the unit operate at all any thoughts?
1 Answer Hi Jack. The clean light will stay on if there is a shorted thermostat or open one. The high limit thermostat part # is WP661566. Thank you. Read More...
Sidney May 31, 2011 for Model Number kudi01ilbs1 Do they have a fault code reset on the control panel on a kitchenaid dishwasher kudi01ilbs1?
1 Answer Hello Sidney. It depends on the fault code you are getting. Some have a reset and some needs the repair to be done to reset. Hope this helps. Read More...
Sidney May 31, 2011 for Model Number kudi01ilbs1 I recently asked a question about my kitchenaid dishwasher kudi01ilbs1 all the lights come on the control panel but when I hit start nothing happens my answer for you all was it maybe the door latch switch and I can check it I checked it and it work fine.
1 Answer Hello Sidney. If the door switch is good, and the start button is not working, you will need to replace the control panel W10757829. Hope this helps. Read More...
Sidney May 26, 2011 for Model Number kudi01ilbs1 When checking door switch, what should the ohm meter read?
1 Answer Hello Sidney. You will set the meter to test for continuity. If the Switch reads NC and COM it should read closed. If it say NO and COM it should read open. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Sidney May 24, 2011 for Model Number kudi01ilbs1 My kitchenaid dishwasher model number kudi01ilbs1 cycle light and option light and cancel buttons work, but when I hit start the dishwasher won't start.
1 Answer Hello Sidney! You will need to make sure that the door is closing and latching properly. Also, check your door switches WP8269209. If the door is not reading that it is closed the unit will not start. You can test these with a multimeter MA-DM1. Here is a link from our free repair forum you can refer to for help with using a multi meter. Hope this helps, thaks! http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
John B. April 24, 2011 for Model Number KUDK03ITBL3 Will not start. Lights flashing on door. All conection are good.
1 Answer Hello John. You will need to test the door switch and see if it is bad. When the door closes, the switches should make up. Test the switch with the power off to the unit. You can test this with a multi-meter MA-DM1. Here is a link on how to use a multi-meter. Hope this helps. http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Donna Q. April 08, 2011 for Model Number 66516693200 Name of the switch that starts the cycle when you close the door.
1 Answer Hi Donna. If you require the switch located on the door latch, it would be part WP8269209. If you need the start button you will want to order the control panel part WP8537820. Hope this helps! Read More...