Matt November 25, 2012 for Model Number du850swps3 whirlpool I need some installation or put back toget help. So today my dishwasher was working fine, then for some reason I pulled the float, at which I pulled it completly out. Now it wont fill with water. I took the kick plate apart and found the following part down there, found a little piece from the float gues, like the lock for it and p/n 8318219. I put the lock back on, but it still does not work. I belive there is a switch down there that I saw, not sure if it is part of it. Over all I need some help putting the float with the housing, lock and switch all back together. The dishwasher does not get water, however it still pumps the clean rinse in. Please help me on the installation I dont want to pay someone for an easy fix.
1 Answer Hello Matt, To install the float you just push it down into the hole and push the lock back on it. The float should sit at where the switch is located and lower onto and raise off the switch. When switch is down unit will fill. When up it will turn water off. Read More...
Mike February 29, 2012 My dishwasher will not fill up to the float, sometimes it dont even fill up at all.
1 Answer Hello Mike. Based on the information you provided, it sounds like the water valve W10844024 is bad and will need to be replaced. Hope this helps. Read More...
Scott H. September 01, 2011 for Model Number worlpool gu dishwasher Washer does not fill to the point that it is lifting the float switch before running? Shouldn't it lift this switch?
1 Answer Hello Scott. Yes, it should fill enough to lift the float. Based on the information you provided, you will need to replace the water valve. Hope this helps. Read More...