Justin June 06, 2011 for Model Number A312 I think the lid switch might be broken. The washer will run fine and then the lid switch clicks and disengages the plastic arm, shuting the machine down. I can pick the lid up and put it back down and it starts again but then it repeats the same process. What part do you think needs to be replaced? Do you know the part number so I can order it?
1 Answer Hello Justin. Based on the information you provided, it sounds like the lid switch W10820036 is bad, and will need to be replaced. Hope this helps. Read More...
Ken May 26, 2011 for Model Number mat25csaal I am trying to find an out of balance switch. I think that the new door switch kit has been re-engineered to only use one switch. The old system had a switch for the door with 2 connectors N/O and a switch for out of balance that had 3 lead connectors 1-N/O and 1-N/C. Does one switch now replace both?
1 Answer Hello Ken! Yes, the door switch kit W10820036 is the replacement. The kit will include instructions for the new installation. Thanks. Read More...
Dawn April 25, 2011 for Model Number A5000 My washer will fill up with water then quit. At first I could slam the lid a couple times and it would kick back on but now that doesn't even work. Could it be the lid switch?
1 Answer Hello Dawn! You should hear a click when the lid is shut. If you do not hear this click, this will indicate the lid switch has become defective. Your part number is W10820036. Hope this helps! Read More...
Beth April 08, 2011 for Model Number Kenmore model #110.82672110 Washing machine works if lid is dropped. I think the lid switch is the problem. Will this come with instructions for my husband to fix? Not sure how to get the top off?
1 Answer Hello Beth. You will need to check and make sure the switch is tight and not loose. If it is tight, then you will need to replace the lid switch. If you will raise the control panel of the machine, there are two brass colored clips that will need to be released. Once removed, the cabinet will pull off the machine. Hope this helps. Read More...
Forrest March 05, 2011 I have a switch with this part number (661517) but it only has one wire terminal on each side. This picture indicates two terminals on one side. Is this the same part?
1 Answer Hello Forrest. Yes this is the same part. Some of the models have a light, which uses the other terminals. Wire yours up according to the old switch you take off. Hope this helps. Read More...
Guest February 26, 2011 Is the door lid switch the part that shuts the machine off when it is out of balance?