J.H. August 25, 2016 for Model Number ED22TEXHW03 I was wondering what number terminal I will need to put the black wire on for my refrigerator. Thanks very much
1 Answer Hello J.H., For the configuration on the model provided, you should connect the loose black wire to terminal #1 . Read More...
Chefdon August 10, 2016 for Model Number 106.727591 I have a Kenmore freezer Model #106.727591, and have bought the replacement defroster timer #482493. Which terminal does the black wire attach to?
Gary July 11, 2016 for Model Number ED25QFXHB01 Have one of your 8 hr defrost timers W10822278, FSP #483212. Want to check which terminal gets the black wire. Replacing the same part installed by repairman that lasted less than 2 years. It has black wire on terminal 1.
1 Answer Hello Gary. You will need to place the black wire onto terminal number 1 of the new timer as well. Read More...
Adam July 11, 2016 for Model Number ET18PKXGW01 Which terminal do I connect the black wire on defrost timer part 482493?
Darcy July 06, 2016 for Model Number 106.56612500 I've looked and looked and can't find a wiring schematic regarding my Defrost Timer. I'm inquiring as to the correct terminal to connect the loose black wire (terminal #1 or #2). Much appreciation for a correct answer. Thanks, DR
1 Answer Hello Darcy. You will need to place the black wire onto terminal number 2 of the timer. Read More...
Timer July 04, 2016 Replaced defrost timer[482943] Followed instructions as to where timer lead had to go. Plugged in power. All lights are on.Unit is running and can hear it. But about every 30 seconds unit "slows" down and lights flicker. When lights flicker and unit "slows" down I hear a click. The unit then goes back to running the every 30 second mode as mentioned.
1 Answer Hello Timer. Here is a link to our Repair Forum, this is a free service to our customers. Use this link to access the repair for your question. http://forum.appliancepartspros.com/refrigerator-freezer-repair/193358-freezer-fridge-not-cooling.html Read More...
1 Answer Hello Suits. You will need to attach the black wire to the number 2 terminal of the timer. Read More...
1 Answer N.Y. Suits, The black wire on the defrost timer W10822278 will go on the terminal labeled number 2. Read More...
Len June 24, 2016 for Model Number 10670172990 Will your defrost timer simply connect to my existing plug without modifications? My defrost element reads 33 ohms continuity so I'm assuming it is good. What else is there besides the element, timer and bi-metal thing to the defrost cycle? Will a heat probe be OK in my freezer? Thanks
1 Answer Hello Len, The loose lead on the timer will connect to terminal number One on the defrost timer and it will plug right into the existing connector on your unit. The reading on your defrost heater sounds like you have a good element. The only other thing to the defrost cycle on your model is the wiring harness. If by a heat probe, you are referring to a defrost drain heater 819043, it should be fine. Read More...
Steve June 20, 2016 for Model Number Kenmore model 106.9651713 As you can see I have a Kenmore refrigerator (106.9651713). I need to replace the Defrost Timer. I purchased a whirlpool replacement part #482493. My question is : For the model I have which terminal do I place the wire on to? Your answer is much appreciated
1 Answer Steve, For your model you would want to slide the black lead on terminal labeled number 1 on the defrost timer W10822278. Read More...