Alan May 01, 2011 for Model Number PAV3300AWW Upper agitator comes off and wont stay down , If I replace it will the new one stay or do I need more parts?
1 Answer Hello Alan. It sounds like the hole is wore out inside the agitator. If you replace it with a new one, it should be ok. Make sure the bolt is still there to connect the new upper to the lower agitator. Hope this helps. Read More...
Teresa April 25, 2011 for Model Number PAV3360AWW The auger was floating in my washer. Do I need to just replace that part or do I need to replace the base as well? And is it easy to do? Thanks
1 Answer Hello Teresa! You will need to check the bolt down in the center of the auger has came undone or if the plastic that is around the bolt has stripped. If it has stripped replace the auger only, your part number is 21001878. Thanks. Read More...
Hector March 23, 2011 for Model Number pav2360aww Ok, but is there anything I can do about the lint? Like buy something
1 Answer Hello Hector! Make sure that the washer is not being overloaded and also make sure that you have the correct water temp coming into the unit. Hot water should be at 120 degrees and cold water should be above 50 degrees. Also make sure you are not using too much detergent for the load selected. Hope this helps! Read More...
Joe March 22, 2011 for Model Number pav2360aww Is there a different auger to purchase? It seems that the design is very poor and will always fail.
1 Answer Hello Joe! The original auger has been redesigned. We now carry the most updated part from the manufacturer. The part number is 21001878. Thanks! Read More...
Hector March 19, 2011 for Model Number pav2360aww What part of this model washer keeps the lint from sticking to the clothes?
1 Answer Hello Hector. Alot of models have a lint filter built into the upper part of the agitator. Looking through the part list for your model it does not look like your model came with one. Thanks! Read More...
1 Answer Hello. Yes, if the auger is making a noise, you will need to replace it. Thanks. Read More...
Tommy March 09, 2011 for Model Number pav5158aww The auger keeps moving up & down during the wash cycle so I asume it's shot. So do I need the auger along with the base part also or what. I would appreciate if you could let me know what to get. Thanks Tommy
1 Answer Hello Tommy. You should just need the auger. This is the part that the bolt geos through to attach it to the transmission shaft. Hope this helps. Read More...