1 Answer Hello Robert. You will need to check and see if the lid switch 3949247V is bad or broken. If so, it can cause the problems your having. It should read closed with the lid closed and open with the lid open for continuity. You can test this with a multi-meter TJMA-DMT3. Here is a link on how to use a multi-meter. Hope this helps.http://forum.appliancepartspros.com/oven-repair-including-ranges-cooktops/4810-how-check-continuity-ohmmeter.html Read More...
Ken June 22, 2011 for Model Number 110.20612991 Water would not stop filling. Does the water level switch need replacing?
1 Answer Hello Ken! It could be the water level switch W10337780 or the water inlet valve 285805. The best way to diagnose to see which one has become defective is to run the washer and unplug it. If the water continues to fill, replace the water inlet valve. If the washer stops filling when unplugged replace the water level switch. You will also need to check the pressure hose to make sure it is not clogged before replacing the water level switch. Hope this information helps you! Read More...
Wayne H. May 25, 2011 for Model Number LSR9434PQ4 The water level on super, dose not go up to the expected level of water, it seems to be about two and three quarters to the top edge of the metal rim of tub. If this is the way that it should be then ok. Is there an adjustment that I need to know?
1 Answer Hello Wayne. If the water level is not working properly, then you will need to replace the water level switch W10337780. Hope this helps. Read More...
Tony Q. April 20, 2011 for Model Number Whirlpool LXR7244PQ3 Before I replace the switch on the control panel, is there something else I can check to help me figure out why the "hot" water will not come out when set to "hot" or "warm" setting. When switched to "hot" the machine just hmmmmmms and no water comes out but it will if set at "cold" or "warm-cold" setting.
1 Answer Hello Tony. It sounds like the water valve 285805 is bad and will need to be replaced. Hope this helps. Read More...