Parts for Bosch HBLP651UC/01: Rack Parts

This shelf restores a level, secure storage surface inside your refrigerator. Replacing a broken or missing shelf helps keep items organized and maximizes usable space for everyday food storage. What it does:

• Provides a stable, flat surface to support food containers in the compartment
• Helps organize contents and optimize storage layout
• Replace if cracked, shattered, bowed, missing, or not seating correctly on its supports
• Symptoms of failure include instability, sagging, or frequent spills from uneven support

• One shelf

• Disconnect power before servicing
• Remove items, then lift and slide the old shelf out per your model's design
• Transfer any reusable trim or rails from the original shelf
• Ensure the new shelf is fully seated on its supports before loading

This replacement refrigerator shelf restores a stable, level surface for storing food and beverages. Swap in a new shelf to recover lost space, keep items organized, and reduce spills caused by a damaged or missing shelf.

• Provides a sturdy surface to support containers and organize contents
• Fits into the factory shelf rails for a secure, level placement
• Helps improve visibility and access to items inside the compartment
• Common symptoms: cracked or broken shelf, won't sit level, missing shelf, items tipping or spilling

What's included: 1 shelf Install notes:

• Remove food from the area and lift the old shelf straight out of the side rails
• Wear cut-resistant gloves and handle edges carefully to avoid damage
• Align with the rails and slide/set the new shelf fully into position—do not force
• Reseat and check for obstructions in the rails

This dishwasher water sensor monitors wash-water conditions so the control can adjust cycle time, rinses, and heating for consistent performance. Replace a failed sensor to restore reliable cleaning results and proper automatic cycle adjustments. What it does

• Detects water conditions during the wash cycle and reports to the control
• Helps the dishwasher optimize cycle length, rinses, and energy use
• Common symptoms: unusually long or short cycles, inconsistent cleaning, or sensor-related error messages
• Trigger erratic cycle behavior when the sensor is faulty or contaminated

• One sensor assembly

• Disconnect power and turn off water before servicing
• Access is typically from the underside; place a towel or pan to catch residual water
• Transfer/seat the seal properly if present; fully engage the locking tabs and reconnect the harness
• After installation, run a quick cycle and check for leaks and proper operation

This grille for pan is a replacement trim piece that restores proper airflow and appearance around the appliance pan. It helps keep the pan area protected and looking finished after repair. What it does:

• Covers and ventilates the pan opening to help direct airflow and prevent debris entry
• Replaces a cracked, warped, or missing grille to restore fit and finish
• Helps eliminate rattling or rubbing caused by a damaged trim piece
• Matches OEM fit so it installs cleanly with the original mounting points

• Install requires removal of the surrounding trim or access panel; follow your appliance manual
• Handle carefully to avoid scratching the finish; use non-marring tools as needed
• Disconnect power to the appliance before working in the service area
• Replace damaged clips or screws with OEM fasteners for secure fit