Parts for Broan PME300: Range Hood Parts

Replaces a cracked, broken, or missing sliding front grille panel on your range hood. Restores smooth slide operation and a clean, finished look.

Captures cooking odors in recirculating range hoods for fresher air. Replace when your hood no longer removes smells effectively. Verify fit with your model.

Fan won't start or hums loudly? This capacitor restores proper blower motor function in range hoods. Fixes slow-start and weak airflow issues quickly.

This clear lens covers and protects the light bulb in your range hood while allowing light to shine through. It snaps or screws into place over the hood's lighting fixture. Replace this lens when it's cracked, yellowed, or missing, causing poor lighting or exposed bulbs.

Hood shutting down unexpectedly or overheating? This thermal sensor detects excessive heat and triggers protective shutdown to prevent damage.

This control box is the electrical control module that manages a range hood's fan and lighting functions, restoring reliable power and speed control for ventilation performance. What it does:

• Provides the main electronic control for fan blower speeds and integrated lighting
• Receives inputs from hood switches or remote and switches power to motors and lights
• Replaces a failed or intermittent control module that causes unresponsive or erratic blower/light operation
• Prevents electrical faults caused by damaged or burned-out control circuitry

• Disconnect all power to the appliance before starting any work
• Replace only with the exact part number for your unit
• Follow manufacturer wiring diagrams and secure all connections; use proper connectors/insulation

Restore airflow and eliminate weak ventilation in your range hood. This blower wheel replaces worn blades that reduce suction and leave cooking odors.

Fix rattling or vibration in your range hood with this mounting washer. Secures blower and motor assemblies, restores proper spacing. Simple install.

Range hood not powering on or experiencing electrical issues? This feeder cable delivers power from your home's circuit to the unit. Common repair part.

Range hood not venting properly or letting cold air in? A worn damper assembly may not be opening and closing correctly. Takes about 30 minutes to replace.

This cable stop is a small retaining part that secures a control or cable assembly to the hood/chassis, helping keep cables routed and fastened so controls operate smoothly. It's a simple, replacement fastening piece. What it does:

• Holds and secures a control or actuator cable in place to prevent slipping or disconnection
• Helps maintain correct cable routing so controls and dampers move reliably
• Can eliminate slack or catching that causes loose or intermittent control action
• Commonly used where a cable exits a chassis or attaches to a lever or linkage

• One cable stop/retainer

• Disconnect power to the appliance before gaining access to internal components
• Remove the exterior cover or access panel to reach the cable attachment point
• Reattach the cable into the stop and verify proper routing and tension; test operation before reassembling

Replaces a cracked, broken, or missing sliding front grille panel on your range hood. Restores smooth slide operation and a clean, finished look.

Replace a non-responsive range hood control box when lights or fan speeds won't change. Direct replacement for electronic controls. Moderate DIY repair.

Hood fan won't start or lights won't turn on? This control board restores fan speeds, lighting, and timer functions. Straightforward swap-out repair.

Replace your range hood's control knob if it's cracked, broken, or missing. This knob installs on the control panel to adjust fan speed and lighting settings.

Replace your range hood light lens to restore clear illumination and protect the bulb from grease. Verify fit with your model number before ordering.

Replace your range hood's control knob if the original is cracked, broken, or missing. This knob installs on the control panel for fan speed adjustment.