Parts for Ge GTD86ESPJ0MC: Rear Roller Support Parts

This top mounting bracket secures the appliance's top panel or console components for stable alignment and quiet operation. It replaces a bent or broken top bracket to restore proper fit and reduce vibration. What it does:

• Anchors the top panel or console assembly so doors and controls align correctly
• Prevents top-panel movement, rattling, or gaps that can affect operation
• Restores a secure mounting point if the original bracket is cracked or warped
• Helps maintain correct clearances to protect wiring and adjacent components

• One top mounting bracket

• Disconnect power (unplug appliance or switch off breaker) before installing
• Remove top panel or console fasteners to access the bracket; keep hardware for reuse
• Align bracket, then reinstall and snug screws—do not overtighten to avoid stripping

Package of 12

The Roller Assembly Wheel is an OEM part for GE dryers. It supports the drum and allows it to rotate smoothly during drying cycles, ensuring efficient and quiet operation. The assembly includes the roller, roller axle shaft, and two retaining clips. The roller is threaded on one side and hexagon-shaped on the other, with a tri-ring included for secure installation.

You should replace this roller assembly wheel if it becomes worn or damaged. Common causes of a bad roller assembly wheel include wear and tear from regular use, accumulation of lint and debris, or damage due to overloading the dryer.

Symptoms of a bad roller assembly wheel include:

• Thumping or squeaking noises during operation
• The drum not rotating properly or getting stuck
• Uneven drying of clothes
• Excessive vibration or movement of the dryer

This GE replacement part is also compatible with Hotpoint, RCA, and some Kenmore models.

This thermistor inlet is the inlet temperature sensor that monitors incoming air temperature so the dryer can control heat and cycle length more accurately. It helps maintain consistent drying and protects against overheating. What it does:

• Senses air temperature at the dryer inlet and sends a signal to the control board
• Allows the control to adjust heating elements or gas valve timing for proper drying
• Common symptom: clothes take longer to dry or dryer runs too long
• May help resolve intermittent heating or temperature-related error codes

• Disconnect power to the appliance before servicing to avoid shock or injury
• Handle the sensor and connector gently; avoid pulling on wires
• Install in the original mounting location and secure connector fully

This silicon controlled rectifier (SCR) is an electronic switching device used in appliance control circuitry to regulate power to motors or heating circuits. Replacing a faulty SCR restores reliable power control and helps resolve intermittent or failed operation. What it does:

• Controls and modulates electrical current in control boards and power circuits
• Allows timed or variable power delivery to heating elements or motors in appliances
• Helps stop intermittent operation caused by a failed switching device
• Commonly replaced when an appliance experiences no heat, no motor run, or erratic performance

• Disconnect power to the appliance before servicing to avoid electric shock
• Handle with ESD precautions; avoid touching terminals and static-sensitive areas
• Install the replacement SCR with the same orientation and secure mounting as the original

A replacement screw used to secure panels and components in compatible GE appliances. Replacing missing or damaged screws restores secure mounting, reduces rattling, and helps keep parts aligned during normal operation. What it does:

• Fastens panels, trim, brackets, or small appliance components to maintain proper alignment and fit.
• Keeps internal parts secured to reduce vibration, rattling, or movement during use.
• Replaces stripped, rusted, or missing hardware that can cause loose or misaligned panels.
• Small, non-electrical part — does not affect electrical circuits or controls.

• Disconnect power and unplug the appliance before accessing internal parts.
• Use the properly sized screwdriver to avoid stripping the head; hand-start threads to prevent cross-threading.
• Tighten securely but avoid over-torquing; overtightening can strip threads or damage plastic components.
• Keep track of small parts and hardware; replace any damaged or mismatched screws with the correct OEM part.