Parts for Electrolux GL30CAEC: 03 - Recommended Spare Parts

This genuine control panel replaces a cracked, damaged or worn console surface to restore the appliance's exterior and support the console controls. It provides a direct fit for models that list this exact part number. What it does

• Serves as the front surface for the appliance control console and provides mounting for buttons, displays or switches
• Replaces cracked, warped or cosmetically damaged panels that expose internal components
• Helps protect electronic controls and wiring from spills and debris
• Restores the factory appearance of the console after impact or wear

• Follow the appliance manufacturer's disassembly steps to access and remove the console; disconnect power before starting
• Handle with care to avoid scratching the finish or damaging attached trim or mounting tabs
• Retain any screws, bezels or clips from the original panel for reuse unless replacement hardware is specified
• If electronic components need transfer, ground yourself and follow static-safety practices

Control knob for grill burner valve operation. Installs on the front control panel. Replace if cracked, broken, loose, or missing for proper valve control.

Replacement wire for your grill. Installs in the control or ignition system. Order a new one if your existing wire is frayed, damaged, or broken.

The grill igniter wire is the electrical cable that connects the igniter to the power supply on your gas grill. It carries the spark current needed to ignite the burners when you press the ignition button. Replace this wire if your grill won't spark, the igniter clicks but produces no flame, or the wire is visibly cracked or burned.

Burners won't light or spark is weak? This ignitor module restores reliable spark generation to ignite gas burners. Straightforward repair.

This is a small metal cap that sits on top of a surface burner on a gas range or cooktop. It distributes the flame evenly around the burner for consistent heating. Replace this cap if it is chipped, warped, corroded, or if the burner flame appears uneven or yellow.

Replacement mounting screw for grill assembly. Secures components and panels in place. Order a new screw if original is stripped, missing, or damaged.

Replacement mounting screw for grills. Secures panels, trim, brackets, and assemblies. Needed when original screw is missing, stripped, or damaged.

This is a mounting nut used to secure the bottom door pivot on a range or oven. It holds the hinge pin or pivot bracket in place so the door swings properly and stays aligned. Replace this nut if it is stripped, corroded, or missing, which can cause the oven door to feel loose or hang unevenly.