Parts for Whirlpool 4YED20TKFN02: 06 - Refrigerator Door Parts

Replaces a worn or broken upper closure cam on your refrigerator door hinge. Ensures proper door alignment and smooth closing action when damaged.

The Screw is an OEM replacement part for Whirlpool appliances. The precise threads allow screws to join or assemble other parts securely. 

Causes of a bad screw can include stripping, cracking, or loss of threads due to repeated installation/removal over time. Corrosion is also possible depending on environmental conditions.

Symptoms of a bad screw include: 

• Loosened or detached components that were once fastened 
• Reduced structural integrity of connections or assemblies
• Potential safety hazards if critical parts become dislodged

This OEM Whirlpool part is also compatible with Maytag, KitchenAid, Jenn-Air, Amana, Magic Chef, Admiral, Norge, Roper and some Kenmore models.

Chrome. No longer made in black.

Top door hinge thimble bearing supports the upper refrigerator hinge for smooth door operation. Replace if cracked, worn, or causing popping noises.

Replacement screw secures appliance panels, brackets, and internal components. Needed when original screws are stripped, missing, or damaged during repair.

Replace your refrigerator door gasket to seal cold air inside and prevent condensation. Signs include visible wear or warm interior. Confirm fit by model.

Almond. For black order WP2186649B. For white order 2186649W.

White retainer bar that snaps across refrigerator door bins to secure items. Replace this trim piece if cracked, broken, or missing to restore stability.

This replacement screw secures panels, brackets, and internal components in Whirlpool-built appliances. Use it to replace missing or stripped hardware to restore a snug fit, reduce rattling, and maintain proper alignment. What it does:

• Fastens components to the appliance cabinet or frame
• Helps maintain alignment and proper clearances
• Reduces vibration-related noises from loose or missing hardware
• Common replacement when a screw is lost, corroded, or threads are damaged

• 1 screw

• Disconnect power before service; for gas appliances, also shut off gas supply
• Start threading by hand to avoid cross-threading; use the correct driver bit
• Tighten snugly without overtightening to prevent stripping
• Inspect and replace any worn clip/nut or damaged threads

Right hand side. Color: White. It measures about 3 inches high by 4 inches deep. For left hand side order WP2196190. For kit with LH and RH end cap order 4388286.

Left hand side. Color: White. It measures about 3 inches high by 4 inches deep. For right hand side order WP2196189. For kit with LH and RH end cap order 4388286.

Size: 1/4 inch hex head, 10-12 x 1/2 inch.