Remington Engine Parts

Dipstick tube assembly for push and self-propelled walk-behind mowers. Replaces cracked, broken, or missing dipstick tubes to maintain proper oil level.

Replacement oil drain plug for outdoor power equipment engines. Installs in the oil pan to seal the drain opening. Replace if stripped, cracked, or leaking.

Replaces a cracked, hardened, or broken primer bulb on gas-powered engines. Installs on the carburetor to inject fuel for priming before starting.

This is a plastic fuel tank that stores gasoline for a small engine used in lawn and garden equipment. It connects to the fuel line and carburetor to supply fuel for combustion. Replace this tank if it is cracked, leaking fuel, or has become warped or brittle from age and sun exposure.

Fixes snow thrower that won't start or has a broken pull cord. This recoil starter assembly restores manual starting function. Moderate DIY repair.

Oil fill plug assembly for small engines. Seals the oil fill opening to prevent leaks. Replace if cracked, stripped, or missing to maintain proper seal.

Starter rope won't retract after pulling? This recoil pulley and spring assembly fixes rope retraction issues on mowers and small engines. Direct fit.

This is a complete carburetor assembly for a lawn and garden equipment engine. The carburetor mixes air and fuel in the correct ratio for combustion, enabling the engine to run smoothly. Replace this carburetor if the engine is hard to start, surges, stalls, runs rough, or if fuel is leaking from the carburetor body.

This genuine OEM Part is a choke temperature control rod for lawnmowers. The choke temperature control is the metal piece that regulates the choke temperature allowing for it to function properly within a lawnmower. If the choke function is no longer working efficiently, it might be time to replace the choke temperature control. Luckily, replacing this part is a simple repair.Before beginning, make sure the engine is cool to avoid getting burned. Locate the old choke temperature control rod and remove the screws to the mounting assembly that hold the rod in place. Once removed, lift the old choke temperature control out and away from the mower and set it to the side. Replace with the new control rod and secure the mounting screws. Start up the mower to see if the choke function is working properly. If it does, the installation was a success. This replacement part is sold individually and is compatible with MTD brand lawnmowers.

Carburetor insulator gasket installs between the carburetor and engine block. Replace if cracked, deteriorated, or missing to prevent air leaks.

Replacement oil drain plug for small engines on outdoor power equipment. Needed when original plug is stripped, cracked, or leaking. Installs at oil pan.