Parts for Ge ASH124CRDDA2: Room Air Conditioner Parts

This outdoor/condenser fan motor circulates air across the refrigerator condenser to help remove heat and maintain cooling efficiency. Replaces a failed motor to restore normal condenser airflow and reduce overheating risk. What it does:

• Spins the condenser fan blade to move air across the condenser coils
• Helps the compressor and cooling system run within normal operating temperature
• Commonly replaces motors that hum, don't start, or run intermittently
• Can resolve symptoms like warm fridge compartments or noisy condenser area

• One outdoor/condenser fan motor

• Disconnect power at the breaker or unplug the appliance before starting
• Verify blade clearance and secure all mounting fasteners during reassembly
• Handle wiring connectors carefully; match original wire locations and secure with proper terminals

This top cover is the exterior metal panel that sits over the cooking surface and helps protect internal components while giving the range a finished look. It restores a secure, stable surface and prevents debris from entering the cabinet area. What it does:

• Covers and protects internal controls, wiring, and burner box from spills and debris.
• Helps maintain the correct alignment and spacing of cooktop components.
• Reduces drafts into internal compartments that can affect electronic parts.
• Commonly replaced when the cover is dented, warped, rusted, or damaged from spills or impact.

• Disconnect power at the breaker and, for gas ranges, shut off the gas supply before servicing.
• Remove any burners, grates or trim pieces as needed to access mounting screws; follow OEM diagram for screw locations.
• Handle edges carefully — sheet metal edges may be sharp; wear gloves.
• Tighten fasteners securely but avoid over-torquing; check alignment before fully reassembling.

This inverter assembly converts the microwave oven's control signals into the high-current power supply needed for inverter-style magnetrons, restoring consistent heating and power-level control. Fits inverter microwave systems that use the WJ26X32853 service part. What it does:

• Provides the DC-to-high-current conversion required for inverter magnetron operation
• Restores proper power-level modulation for even heating and accurate cook power
• Commonly replaces a failed inverter when the microwave won't heat or loses power-level control
• Helps eliminate intermittent heating or reduced output caused by a faulty inverter

• Disconnect power at the breaker or unplug the appliance before servicing
• High-voltage components may retain charge; discharge the high-voltage capacitor and follow OEM safety procedures
• Handle circuit boards and connectors carefully to avoid ESD or physical damage

This temperature sensor detects the internal cabinet temperature and sends that signal to the refrigerator control so the unit maintains the correct cooling. It's a direct-replacement thermistor for accurate temperature monitoring and reliable operation. What it does

• Senses internal air temperature and provides the reading to the control board
• Helps regulate compressor/cycle behavior to keep food at set temperatures
• Commonly replaced when the refrigerator runs too cold, too warm, or cycles erratically
• Can fail intermittently and cause temperature fluctuations or incorrect temp readings

• One temperature sensor

• Disconnect power to the appliance before servicing to avoid electrical shock
• Handle the sensor and wiring gently; avoid kinking or crushing the probe or harness
• Note the connector position before removal to ensure correct reinstallation
• If diagnosing, verify sensor continuity with a multimeter and follow OEM testing procedures

This bottom plate assembly replaces the appliance's lower base panel to protect internal components and provide a stable mounting surface. It restores proper support and helps prevent damage from spills and debris. What it does:

• Forms the lower interior base that supports internal components and assemblies
• Shields wiring and parts from drips, crumbs, and other debris
• Helps maintain proper alignment and spacing of components
• Reduces rattles or movement caused by a damaged or missing base

• Disconnect power (and gas if applicable) before starting any repair
• Handle edges carefully; sheet metal can be sharp
• Installation typically requires removing access panels and fasteners to replace the plate