Parts for Ge VPMS05BWT1: Room Air Conditioner Parts

This drain plug seals the washer drain opening to prevent leaks and direct water flow into the drain system. It restores a proper seal so the appliance can drain reliably and helps avoid water pooling under the unit. What it does:

• Seals the washer drain opening to prevent water leaks at the base
• Directs discharged wash water into the drain system for proper drainage
• Common symptom fix: water pooling under or around the washer after a cycle
• Common symptom fix: intermittent leaking from the bottom/front of the cabinet

• Disconnect power and water supply before servicing.
• Access may require removing the rear or front lower access panel depending on model.
• Inspect mating surfaces and any gaskets; clean debris before installing for a proper seal.
• Hand-start the plug, then snug—avoid over-tightening to prevent damage.

This exhaust duct directs dryer exhaust from the appliance to the home vent system, keeping exhaust airflow contained and helping prevent lint and moisture leaks. It's a direct-replacement duct section for affected dryer vent assemblies. What it does:

• Channels hot, lint-laden air from the dryer to the household exhaust vent
• Prevents exhaust leaks that can cause poor drying performance or moisture build-up
• Reduces lint escape at the cabinet-to-vent connection when installed correctly
• Helps maintain proper airflow when combined with a clear, unobstructed vent path

• Disconnect power before servicing the dryer; for gas models, shut off the gas supply and follow safety procedures
• Use proper clamps or HVAC foil tape to secure duct joints and prevent leaks
• Inspect and clean surrounding venting and lint traps while the duct is replaced

This flat exhaust duct connector helps link a low-profile exhaust outlet to the home ducting for improved airflow path in tight installations. It provides a low-profile transition that reduces kinks and keeps exhaust moving efficiently. What it does

• Creates a flat/low-profile transition between the appliance exhaust outlet and the house ductwork.
• Helps reduce air restriction where a standard round duct won't fit.
• Can reduce vibration and rattle caused by misaligned duct connections.
• Commonly replaced when the existing connector is cracked, bent, leaking, or preventing proper venting.

• One flat exhaust duct connector.

• Disconnect power to the appliance and follow all safety precautions before servicing.
• Remove old connector and clean the duct opening; verify correct orientation before attaching.
• Secure with appropriate clamps or UL-listed foil duct tape; avoid using cloth or non-approved tapes.
• Check the connection for leaks and clear any lint or debris after installation.