Parts for Ge AZ65H07EBMW1: Sealed System Parts

This door vent assembly replaces the venting component mounted in the appliance door to help direct airflow and exhaust. It restores proper door airflow path and prevents gaps that can reduce performance or allow debris entry. What it does:

• Provides the door-mounted vent path for airflow and exhaust.
• Seals and directs air through the door opening to maintain intended circulation.
• Can prevent lint, dust, or small debris from entering internal cavities.
• Symptoms of a failing vent: visible cracks, warped or loose vent, reduced airflow, or abnormal exhaust routing.

• Disconnect power (and gas if applicable) before beginning any repair.
• Basic hand tools (screwdriver, nut driver) are typically required to remove the door panel and replace the vent.
• Handle edges carefully; wear gloves to protect hands and avoid damaging the new part.

A rubber compressor grommet that cushions the compressor and helps reduce vibration and noise for more stable, quieter operation. Fits over compressor mount studs to isolate the compressor from the cabinet frame. What it does:

• Absorbs and isolates compressor vibration to reduce rattling and noise
• Prevents metal-to-metal contact between compressor and mounting plate
• Helps protect mounting hardware and compressor casing from wear
• Commonly used when noise, vibration, or movement is noticed around the compressor area

• Disconnect power to the appliance before servicing to avoid shock hazard
• Access the compressor from the rear panel; support the compressor when removing mounts
• Replace any additional worn grommets or mounting hardware for best results

This thermistor holder secures the refrigerator temperature sensor in the correct position so the control board reads accurate air/evaporator temperatures for consistent cooling performance. What it does:

• Holds the temperature sensor/thermistor in place near the evaporator or air duct so the control can monitor temperature.
• Helps ensure accurate temperature readings to prevent overcooling or insufficient cooling.
• Stabilizes sensor location to reduce intermittent or false temperature signals.
• Commonly associated with symptoms like erratic temperature display, long run cycles, or uneven cooling when the sensor is loose or damaged.

• One thermistor holder/mounting bracket.

• Disconnect power to the appliance before servicing to avoid shock.
• Handle the thermistor/sensor carefully; do not pull on wires or bend the sensing element.
• Ensure the sensor is fully seated in the holder and that the holder is secured in its mounting location.