Parts for Ge AZ65H12DBMW2: Sealed System Parts

This door vent assembly replaces the venting component mounted in the appliance door to help direct airflow and exhaust. It restores proper door airflow path and prevents gaps that can reduce performance or allow debris entry. What it does:

• Provides the door-mounted vent path for airflow and exhaust.
• Seals and directs air through the door opening to maintain intended circulation.
• Can prevent lint, dust, or small debris from entering internal cavities.
• Symptoms of a failing vent: visible cracks, warped or loose vent, reduced airflow, or abnormal exhaust routing.

• Disconnect power (and gas if applicable) before beginning any repair.
• Basic hand tools (screwdriver, nut driver) are typically required to remove the door panel and replace the vent.
• Handle edges carefully; wear gloves to protect hands and avoid damaging the new part.

This foam insulator fits on the coil side to cushion, seal and protect the evaporator area—helping reduce vibration, prevent rubbing, and maintain proper airflow around the coil for more consistent cooling performance. What it does

• Cushions the evaporator coil to prevent vibration and rattling noises
• Seals gaps around the coil to help direct airflow where needed
• Protects coil edges from abrasion against adjacent components
• Helps reduce moisture migration that can cause ice buildup in the coil area

• Disconnect power to the appliance before beginning any work
• Access may require removing the evaporator cover or interior panels
• Fit the foam to the coil edge and adjacent frame; replace if torn or compressed

A rubber compressor grommet that cushions the compressor and helps reduce vibration and noise for more stable, quieter operation. Fits over compressor mount studs to isolate the compressor from the cabinet frame. What it does:

• Absorbs and isolates compressor vibration to reduce rattling and noise
• Prevents metal-to-metal contact between compressor and mounting plate
• Helps protect mounting hardware and compressor casing from wear
• Commonly used when noise, vibration, or movement is noticed around the compressor area

• Disconnect power to the appliance before servicing to avoid shock hazard
• Access the compressor from the rear panel; support the compressor when removing mounts
• Replace any additional worn grommets or mounting hardware for best results

AC won't cool or clicks repeatedly? A failed compressor overload protector cuts power to prevent overheating. This thermal switch restores normal operation.

Fix water leaking from your air conditioner with a new thermostatic drain valve. Controls condensate drainage to prevent overflow and water damage.

Air conditioner not cooling properly or running constantly? The thermistor monitors temperature and signals the control board. Direct fit replacement part.

Fix inconsistent cooling or temperature swings by replacing the thermistor holder that secures your air conditioner's sensor in the proper position.

Fix an air conditioner that won't cool properly or cycles on and off frequently with this outdoor thermistor. Common repair for temperature sensing issues.

Fix inadequate fresh air circulation in your room air conditioner with this make up air module kit. Restores proper ventilation and air quality.