Parts for Ge AZ65H15EACW8: Sealed System Parts

Fix weak cooling or warm air issues with this evaporator coil. Essential for restoring proper cooling performance in room air conditioners. Moderate repair.

This foam insulator fits on the coil side to cushion, seal and protect the evaporator area—helping reduce vibration, prevent rubbing, and maintain proper airflow around the coil for more consistent cooling performance. What it does

• Cushions the evaporator coil to prevent vibration and rattling noises
• Seals gaps around the coil to help direct airflow where needed
• Protects coil edges from abrasion against adjacent components
• Helps reduce moisture migration that can cause ice buildup in the coil area

• Disconnect power to the appliance before beginning any work
• Access may require removing the evaporator cover or interior panels
• Fit the foam to the coil edge and adjacent frame; replace if torn or compressed

A rubber compressor grommet that cushions the compressor and helps reduce vibration and noise for more stable, quieter operation. Fits over compressor mount studs to isolate the compressor from the cabinet frame. What it does:

• Absorbs and isolates compressor vibration to reduce rattling and noise
• Prevents metal-to-metal contact between compressor and mounting plate
• Helps protect mounting hardware and compressor casing from wear
• Commonly used when noise, vibration, or movement is noticed around the compressor area

• Disconnect power to the appliance before servicing to avoid shock hazard
• Access the compressor from the rear panel; support the compressor when removing mounts
• Replace any additional worn grommets or mounting hardware for best results

This compressor overload protects the refrigerator compressor from overheating and electrical overcurrent, helping prevent compressor burnout and premature failure. It restores proper compressor protection so the cooling system can run reliably. What it does

• Senses excessive current/temperature at the compressor and interrupts power to prevent damage
• Stops compressor from attempting to run when internal protection is triggered, which can reduce buzzing or repeated start attempts
• Helps prevent compressor burnout and prolonged electrical faults from damaging the cooling system
• Commonly replaced when compressor won't start, hums continuously, or trips the circuit repeatedly

• Disconnect power to the appliance before inspecting or replacing the overload
• Handle the part carefully; avoid crushing or bending terminals and mounting tabs
• The overload matches the compressor terminal layout before installation

Fix water leaking from your air conditioner with a new thermostatic drain valve. Controls condensate drainage to prevent overflow and water damage.

Fix inconsistent cooling or temperature swings by replacing the thermistor holder that secures your air conditioner's sensor in the proper position.

Fix a room air conditioner that won't cool properly or cycles incorrectly with this temperature sensor thermistor. Common repair for faulty cooling.

This screw secures a solenoid or solenoid-mounted component to its valve or mounting bracket, restoring proper fit and preventing movement. A simple replacement for a stripped, missing or loose mounting fastener. What it does

• Fastens solenoid assemblies or related brackets to their valve/body
• Helps stop solenoid movement, rattling or misalignment caused by a loose or missing screw
• Used when replacing a corroded, damaged or missing solenoid mounting screw
• Small replacement part that ensures the solenoid stays properly seated during operation

• Unplug the appliance or shut off power before servicing.
• Use the correct screwdriver and avoid overtightening to prevent stripping threads.
• Keep small parts away from children and pets; retain any washers or clips that may be reused.
• If other mounting hardware appears damaged or corroded, inspect the assembly and replace additional parts as needed.