Dishwasher Flapper Spring Parts
Genuine Bosch part
By: Bosch
Part Number: 00092188
Dishwasher not filling with water or soap not dissolving? The water inlet valve controls water flow into your dishwasher. Takes about 1 hour to replace.
This part fixes the following symptoms
-
overflowing
-
Will not fill with water
See more...
Do-It-Yourself Stories from Customers like You
Dishwasher would not clean dishes soap compartment would open but soap still in compartment Rodney K. • Honolulu , HI • October 02, 2014
The indications made me think the dishwasher was not shooting water. I checked the water valve with a voltmeter and it was getting power to open. I disconnected the line to make sure the water line was not plugged. Then I bypassed the door switch and ran the dishwasher with the door open and did not see the water filling which pointed to the inlet valve. I ordered the valve which came quickly. Replaced the valve and now the dishes are clean!
Read more
More
$234.42
- Compare At:
-
$281.30
- You Save:
-
$46.88
Genuine Frigidaire part
By: Frigidaire
Part Number: 154246402
This small check ball helps control water flow inside the refrigerator's water/ice system to prevent backflow and ensure proper filling. It restores reliable water seating where valves or distributor ports use a ball-style check. What it does:
- Acts as a one-way seal to stop water from flowing backward into the supply line or valve bore
- Helps the ice maker and dispenser fill correctly by allowing water in but not back out
- Common symptom: intermittent or incomplete ice maker fills
- Common symptom: slow or continuous dripping from dispenser or valve area
What's included: One check ball. Install notes:
- Shut off water supply and unplug the appliance before starting
- Small part — handle carefully and note orientation/seat before removal
- Inspect valve bores and seals for debris; clean area before installing new check ball
Do-It-Yourself Stories from Customers like You
Wouldn't drain dishwasher Larry N. • New Bern , NC • January 13, 2019
Just needed a part that I lost during disassembly. Of course I found it after I got the replacement....??
Read more
More
$57.39
- Compare At:
-
$68.29
- You Save:
-
$10.90
Genuine Frigidaire part
By: Frigidaire
Part Number: 5300809703
Counterbalances your dishwasher door for smooth opening and closing. Replace if cracked, broken, or fatigued to prevent door from dropping or slamming.
Do-It-Yourself Stories from Customers like You
Dishwasher door broke Vincent D. • Collingswood , NJ • January 25, 2020
So I noticed a few months ago that the dishwasher door felt a lot heavier than it used to. Then just recently I opened it and heard something snap and the door came crashing down onto my foot! Ouch!! The door was still able to close but opening it required it being fully lowered by hand. I had no idea how heavy the dishwasher door was! So I got down onto the kitchen floor with a flashlight. I removed the metal panel at it’s base by lifting it up and pulling it out. Once I was able to get a...
Read more
More
$46.35
- Compare At:
-
$55.62
- You Save:
-
$9.27
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8274220
Replacement water inlet valve that controls water flow into the refrigerator's dispenser and ice maker, restoring proper filling and preventing overflows. Direct-fit design replaces the original valve on compatible Whirlpool refrigerators. What it does:
- Regulates water flow from the household supply to the refrigerator dispenser and ice maker.
- Opens when the dispenser or ice maker calls for water and closes to stop flow and prevent overfilling.
- Common symptoms: no water from the dispenser, slow/weak fill, ice maker not filling, or water leaking at the valve.
- Designed to match the original valve's function and plumbing connections for straightforward replacement.
What's included: One water inlet valve. Install notes:
- Disconnect power to the appliance and shut off the water supply before starting any work.
- Use basic hand tools to remove and reinstall mounting screws and water line fittings; support lines to avoid stress on fittings.
- Inspect and replace any damaged O-rings or supply tubing; tighten fittings securely but avoid overtightening.
- After installation, turn water on slowly, check all connections for leaks, then restore power and verify dispenser/ice maker operation.
Do-It-Yourself Stories from Customers like You
Dishwasher wash not filling with water Richard D. • Old Forge , PA • December 19, 2014
Changed inlet valve super easy on my whirlpool dishwasher took the front kick panel off turned off water and electricity the valve was right out front bottom left one small sheet metal screw held it on disconnected plug and 5/8 water line and hose with clamp for fill to tub just reverse for install of new valve
Read more
More
$114.95
- Compare At:
-
$138.59
- You Save:
-
$23.64
Genuine Bosch part
By: Bosch
Part Number: 00424099
The Impeller Jug is an OEM part for Bosch dishwashers. Located inside the wash chamber, the impeller jug is responsible for evenly distributing water throughout the dish rack during the wash cycle. It features strategically placed holes and channels that work with the spray arms to direct water flow and ensure all dishes receive thorough coverage.
Symptoms of a bad impeller jug include:
- Incomplete cleaning even on short or heavy wash cycles
- Dirty dishes remaining at the end of the cycle
- A buildup of food or grime deposits inside the wash chamber
- Off-balanced or excessive noise levels during washing
Causes of failure can be mineral or scale buildup inhibiting water flow, cracked or damaged casing allowing leaks, or worn impeller fins no longer efficiently dispersing water. Over time, hard water deposits and normal use can degrade performance.
This OEM Bosch part is also compatible with Thermador, Gaggenau, and some Kenmore dishwashers.
Do-It-Yourself Stories from Customers like You
Dishwasher was not cleaning Matthew F. • Severna Park , MD • February 05, 2021
1) Cleaned all sprayer arms. Many of the outlet holes were clogged with small debris (mostly small bits of food and a Jolly Rancher candy wrapper).
2) Removed circulation pump to clean impeller assembly. It was really clogged with stuff (more candy wrapper, shards of glass, a small metal screw). Luckily impeller fins were intact.
3) Re-assembled. Watch for some sharp edges when re-connecting sump well.
4) Performed three or so test wash cycles pulled out from under counter to make sure I had...
Read more
More
$33.34
- Compare At:
-
$39.34
- You Save:
-
$6.00
Genuine Lg part
By: Lg
Part Number: 4975DD1001A
This guide assembly is the track that supports and directs a dishwasher rack as it slides in and out. Replace a worn or damaged guide to restore smooth rack movement, alignment, and reliable loading. What it does:
- Provides the sliding path that supports and guides the dishrack
- Maintains rack alignment to prevent derailment
- Helps the rack extend and retract smoothly without binding
- Common symptoms: rack hard to slide, tilts or falls off track, scraping/grinding noises, visible cracks or broken tabs on the guide
What's included:
Install notes:
- Disconnect power and shut off water before servicing the dishwasher
- Pull the rack out and remove any end caps or stops to access the guide
- Release locking tabs or screws, note orientation, and swap the old guide with the new one
- Reinstall stops/end caps and test rack travel for smooth operation
Do-It-Yourself Stories from Customers like You
Drain hose had a crack and the guide assembly looked bad Mike L. • Oxford , FL • March 07, 2018
I replaced both items. And it was easier than I thought.
Read more
More
$128.67
- Compare At:
-
$154.40
- You Save:
-
$25.73
Genuine Ge part
By: Ge
Part Number: WD12X445
Fix dishwasher overfilling or not filling properly with a new float dome. Protects the float sensor for accurate water level control. Easy 15-minute repair.
Do-It-Yourself Stories from Customers like You
1 not draining properly 2 not cleaning properly 3 not filling properly 4 not running properly 5 sump and sump cap was filthy 6 James W. • San Diego , CA • March 19, 2017
1. Replaced the Dishwasher motor and pump assembly. 2. Replaced the lower arm sprayer. 3. Replaced the Sump and filter. Replaced both the inlet and outlet hoses. 4. Replaced the Airgap. 5. Replaced Float Dome. 6. Replaced Water Inlet Valve.
Parts $220 for Dishwasher
Estimated Labor $400.00
Labor $0.00
Parts $100.00 for Pullout Faucet
Estimated Labor $175.00
Labor $0.00
Read more
More
$15.52
- Compare At:
-
$18.62
- You Save:
-
$3.10
Genuine Whirlpool part
By: Whirlpool
Part Number: WP4171237
Replacement door spring for dishwashers. Restores proper tension to prevent door from dropping or falling when opened. Install to replace broken, worn, or weak springs.
More
$21.95
- Compare At:
-
$25.90
- You Save:
-
$3.95
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8519552
Fix dishwasher overflows or won't fill issues. This water level float detects proper fill levels. Replaces broken or stuck floats causing drainage problems.
More
$54.95
- Compare At:
-
$65.25
- You Save:
-
$10.30
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10116816
Replacement tension spring for dishwasher doors and mechanisms. Restores proper return force when the original spring is broken, stretched, or missing.
More
$4.95
- Compare At:
-
$5.89
- You Save:
-
$0.94
Genuine Whirlpool part
By: Whirlpool
Part Number: 674744
This spring kit replaces worn or broken return springs in the applicable assembly, restoring proper tension and smooth movement so the mechanism operates reliably throughout the cycle and returns to its proper position. What it does:
- Provides the correct tension to move or hold parts in place
- Helps resolve weak return action, sticking, failure to engage/latch, or sagging components
- Can reduce noise caused by loose or fatigued springs
- Maintains consistent operation throughout the appliance's cycle
What's included:
- Manufacturer-supplied spring kit
Install notes:
- Disconnect power; turn off water supply if applicable
- Springs are under tension—use eye protection and release carefully
- Note original spring routing and attachment points before removal
- Replace both for balanced operation
Do-It-Yourself Stories from Customers like You
Dishwasher door springs broken Joe H. • Renton , WA • April 09, 2016
Replaced the broken springs and works perfectly. The kit was perfect. The instructions were perfect. Kudos to Appliance Parts Pro for making it so easy and timely.
Read more
More
$54.95
- Compare At:
-
$66.36
- You Save:
-
$11.41
Genuine Samsung part
By: Samsung
Part Number: DD61-00245A
Replacement door spring assembly for dishwashers. Installs on door hinges to balance door weight and prevent dropping. Needed when original is broken or worn.
Do-It-Yourself Stories from Customers like You
Rope pulley on saumsung dishwasher broke Colleen G. • Virginia Beach , VA • September 18, 2017
I ordered 2 new springs and 2 new rope pulley assemblies from AppliancePartsPros. I found a youtube video to show how to make the repairs. I am 63 years old and have not done any repairs like this, but repair service for Samsung appliances is cost prohibitive. Since the dishwasher was 9 years old I figured if I screwed it up irretrievably I would just buy a new one. Fortunately I was able to make the repairs and the dishwasher works fine!
Read more
More
$80.95
- Compare At:
-
$96.33
- You Save:
-
$15.38
Genuine Bosch part
By: Bosch
Part Number: 00029014
$15.95
- Compare At:
-
$18.98
- You Save:
-
$3.03
Genuine Frigidaire part
By: Frigidaire
Part Number: 154764401
$19.21
- Compare At:
-
$23.05
- You Save:
-
$3.84
Genuine Frigidaire part
By: Frigidaire
Part Number: 5300807601
Replacement door spring for dishwashers. Installs inside the door hinge to provide tension and smooth operation. Replace if broken, stretched, or missing.
More
$61.56
- Compare At:
-
$73.26
- You Save:
-
$11.70
Genuine Whirlpool part
By: Whirlpool
Part Number: W11814886
Do-It-Yourself Stories from Customers like You
The heating element and float switch were broken. Calvin W. • Burke , VA • May 14, 2023
Replacing the heating element and float switch with AppliancePartsPros.com hardware and Repair Clinic YouTube videos. Just followed the videos and made the swaps. Was able to complete and test all repairs in a single evening.
Read more
More
$47.54
- Compare At:
-
$52.82
- You Save:
-
$5.28