Dryer Run Vent Push Button Switch Parts
Genuine Whirlpool part
By: Whirlpool
Part Number: W10875909
This is a chrome-finished timer knob that attaches to the timer shaft on the dryer's control panel, allowing you to select and start drying cycles. It is made of plastic with a metallic chrome appearance. Replace this knob if it is cracked, broken, or no longer grips the timer shaft properly, making it difficult to turn or set the dryer cycle.
Do-It-Yourself Stories from Customers like You
Whirlpool washing machine with broken door hinge. Adrian H. • Longmont , CO • February 26, 2024
I ordered the door hinge and bushing. I watched the online video showing the replacement procedure. The parts were correct. It was easy to replace. The door works great now. Very pleased with the process and results.
Read more
More
$50.57
- Compare At:
-
$59.67
- You Save:
-
$9.10
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10411937
Dryer won't start or run? A faulty belt switch often causes this when the belt snaps or slips. This switch monitors belt tension and is a fairly easy fix.
Do-It-Yourself Stories from Customers like You
Drum wouldnt turn power to control panel but wouldnt start Andy S. • Arlington , VA • November 03, 2016
Replaced motor "triple switch" Part Number: AP6021090 and the thermal fuse
Read more
More
$28.43
- Compare At:
-
$33.83
- You Save:
-
$5.40
Genuine Whirlpool part
By: Whirlpool
Part Number: W11050715
This replacement switch restores reliable on/off signaling to the circuit it controls, helping your appliance start, stop, and respond correctly. A worn switch can cause intermittent operation, no response, or lights and functions that don't activate. What it does:
- Provides an electrical open/closed signal to enable functions like starting a cycle, powering a motor or light, or shutting a feature off
- Acts as a safety/position interlock (such as door, lid, float, or hood) depending on the model
- Typical symptoms include won't start, won't stop, light won't turn on/off, or intermittent operation
- Can be checked with a multimeter for continuity when actuated
What's included:
Install notes:
- Disconnect power before servicing; turn off gas or water supply if applicable
- Access the switch, note wire locations, and transfer leads one at a time to the new switch
- Mount securely, ensure the actuator aligns and wires aren't pinched
- Reassemble and test operation before finalizing
More
$9.49
- Compare At:
-
$9.54
- You Save:
-
$0.05
Genuine Ge part
By: Ge
Part Number: WH01X10748
Replace your washer's broken, cracked, or missing control knob with this rubberized grip selector dial. Installs on the control panel for secure turning.
Do-It-Yourself Stories from Customers like You
There were two problems with my front loading washer the first was a cover plate over a lint compartment. It was the cycle knob that was broken off Price C. • Westborough , MA • October 04, 2019
I ordered the parts via my cell phone. The parts were shipped overnight express. I had them shipped to my main residence in Massachusetts. I took them up 2 days later to my summer home in Maine. I put the plate on and 5 seconds, I put the new knob on and another five seconds. The entire repair took less than
Read more
More
$24.95
- Compare At:
-
$29.94
- You Save:
-
$4.99
Genuine Speed Queen part
By: Speed Queen
Part Number: 803118P
Replaces a worn, cracked, or broken timer knob assembly on your washer. Mounts on the timer shaft to restore secure grip and smooth cycle selection.
More
$7.66
- Compare At:
-
$9.12
- You Save:
-
$1.46
Genuine Whirlpool part
By: Whirlpool
Part Number: WP307458
Replace your broken, cracked, or missing range surface burner control knob. Installs on the control valve stem to adjust heat levels on cooktops.
Do-It-Yourself Stories from Customers like You
Stove top knobs Bonnie F. • Rancho Cordova , CA • January 02, 2020
Replaced them with Whirlpool part that I was pleased to find.
Read more
More
$21.46
- Compare At:
-
$25.54
- You Save:
-
$4.08
Genuine Ge part
By: Ge
Part Number: WE4M411
Dryer won't heat or overheating? The temperature switch controls heat settings. DIY-friendly repair—just swap wires and reassemble. Takes 20 minutes.
Do-It-Yourself Stories from Customers like You
The timer was sticking to the point where the knobs were stripping out Peter A. • Dallas , OR • December 16, 2014
I unscrewed the 3 Phillips screws on the back of the dryer controls housing, then it folds forward for access to each control switch. the old one popped out, and I swapped the wires using a needle nose pliers, one by one, from the old switch to the new switch. The part was an exact fit, and popped right back into the housing. I screwed the 3 screws back in, pushed on the new knob, and it looks and works like new !
Read more
More
$64.70
- Compare At:
-
$76.99
- You Save:
-
$12.29
Genuine Whirlpool part
By: Whirlpool
Part Number: WP3399640
Dryer won't heat or overheats on low settings? A faulty temperature selector switch prevents proper heat control. Easy DIY fix in 10-15 minutes.
Do-It-Yourself Stories from Customers like You
My kenmore dryer was not gnitind so therefore no heat also my washer was leaking under the machine Bill K. • Midland Park , NJ • November 24, 2014
THE WSHER WAS EASY BECAUSE THE DRAIN PUMP HAD TWO PENNIES INSIDE IT AND THEY CRACKED THE HOUSING.EASY FIX REPLACING THE DRAIN PUMP. WORKS LIKE A CHARM. DRYER WAS A BIT MORE WORK.I CHANGED THE IGNITER FIRST WITH YOUR ADVICE. STILL NOTHING. I THEN CHANGED THE COIL VALVE KIT. NO LUCK. NEXT WAS THE TEMP SWITCH ON THE PANEL. STILL NO GOOD.FINALLY THE THERMAL FUSE WAS RECOMMENDED. I WAS ABLE TO PURCHASE ONE LOCALLY AND IT WORKED . GREAT RELIEF.THANKS FOR ALL THE HELP AND RECOMMENDATIONS. YOUR...
Read more
More
$62.61
- Compare At:
-
$74.51
- You Save:
-
$11.90
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8181881
Color: Blue. For gray order WP8181859.
Do-It-Yourself Stories from Customers like You
The control know on my duet washing machine was broken Kathi K. • Milton , DE • July 22, 2014
I purchased a replacement knob from AppliancePartsPros and replaced the broken knob. the ApplicanceParts website was terrific. I didn't need the washer model number to choose the proper knob because the illustration was perfect. After ordered, the knob arrived within a day. The time expended from ordering to repair was less than 15 minutes. Thanks so much.
Read more
More
$28.43
- Compare At:
-
$33.83
- You Save:
-
$5.40
Genuine Whirlpool part
By: Whirlpool
Part Number: WP8182050
Front load washer control knob. Color: Pewter. For gray order WP8181859. For Biscuit order WP8182049. For blue order WP8181881.
Do-It-Yourself Stories from Customers like You
Broken knob Kevin M. • Ambler , PA • January 22, 2018
I replaced it.
Read more
More
$54.25
- Compare At:
-
$64.56
- You Save:
-
$10.31
Genuine Whirlpool part
By: Whirlpool
Part Number: 279872
This fixed-value resistor is an electrical component used in select dryers to limit current in a specific control circuit. It helps the timer or electronic control operate correctly by dropping voltage to safe, design-intended levels.
- Provides precise resistance to reduce voltage/current in the designated dryer circuit
- Supports proper operation of the timer, control board, or end-of-cycle signal (varies by model)
- Failure may present as a timer that won't advance, an inoperative signal/buzzer, or irregular cycle behavior
- Replace if visibly burned/damaged or if testing shows an open or shorted condition
What's included: One resistor Install notes:
- Disconnect power to the appliance before servicing
- Access the console/wiring harness and note original wire routing
- Make secure, insulated connections and route the resistor/leads exactly as original to avoid heat or chafing
- After installation, run a test cycle to ensure proper operation of the affected function
Do-It-Yourself Stories from Customers like You
Timer wouldn't advance on my dryer John L. • Oblong , IL • March 22, 2016
I ordered a new timer and installed it with the help of the videos provided and this did not solve my problem so I chated with the pros @ Appliance Parts Pros and told them my problem and they told me the problem and recommended the part I needed and With the incredibly fast shipping I had the part the next day. I installed it and now my dryer timer works great.Thanks to APPs for their help and ease of ordering and fast shipping. I highly recommend AppliancePartPros and will definitely use...
Read more
More
$46.35
- Compare At:
-
$55.16
- You Save:
-
$8.81
Genuine Frigidaire part
By: Frigidaire
Part Number: 134011703
Color: white. It measures about 3 inches in diameter.
Do-It-Yourself Stories from Customers like You
Broken dryer knob Randy D. • Greenfield , TN • December 16, 2018
Replaced the broken knob with a new one.
Read more
More
$52.68
- Compare At:
-
$63.22
- You Save:
-
$10.54
Genuine Whirlpool part
By: Whirlpool
Part Number: WP37001184
Restore clear, reliable control of your appliance's timer. This two-piece timer knob and dial replaces worn or broken controls so you can accurately set cycles and read the settings again.
- Turns the timer shaft to select and adjust cycles
- Dial provides readable cycle markings and protects the panel
- Helps resolve issues like a knob that spins freely, cracks, or won't stay on
- Addresses missing or unreadable dial markings that make settings hard to see
What's included: One timer knob and one dial. Install notes:
- Disconnect power before servicing
- Pull off the old knob; remove any retaining clip if present
- Release tabs to remove the old dial; align and snap the new dial into place
- Align the knob with the timer's D/flat shaft and press firmly until fully seated
Do-It-Yourself Stories from Customers like You
Broken timer knob worn out door switch Kurt H. • Quakertown , PA • January 01, 2016
The timer knob simply pulls off the shaft with a solid, steady pull. Cleaned the timer cavity of lint/dust buildup. Aligned the keying flat of the shaft and knob and pushed the new knob on with careful, steady pressure until it was obviously seated. No tools required other than a vacuum.
The door switch would sometimes not shut the dryer off when the door was opened. New switch came with new fast-on connectors. Replacement required opening the top cover of the dryer and hinging it up. This...
Read more
More
$56.34
- Compare At:
-
$67.04
- You Save:
-
$10.70
Genuine Whirlpool part
By: Whirlpool
Part Number: W10853910
This control knob attaches to the appliance's control shaft so you can select settings with a solid, positive feel. Replace a cracked, stripped, or missing knob to restore smooth operation and a clean, finished look.
- Attaches to a switch or valve shaft to select temperatures, burner levels, or cycles
- Transfers your hand turn to the control shaft for accurate setting changes
- Common symptoms: cracked hub, spins without engaging, wobbly/loose, falls off, or missing
- Helps maintain a uniform appearance across the control panel
What's included: 1 control knob Install notes:
- Disconnect power (and shut off gas, if applicable) before servicing
- Pull the old knob straight off the shaft; avoid prying against the control panel
- Align the insert with the shaft's flats or splines and press straight on until fully seated
- Match position- and finish-specific knobs to the original on models that use different knobs per location
Do-It-Yourself Stories from Customers like You
Knob on dryer had a lot of play in since purchased 6 months ago finally stopped working altogether Jil S. • Glen Allen , VA • November 19, 2023
Ordered a knob that was compatible. Worked great only it did not have a pointer telling you what setting you were on. This was solved by using a magic marker once we figured out where to put it.
Read more
More
$49.51
- Compare At:
-
$58.92
- You Save:
-
$9.41
Genuine Frigidaire part
By: Frigidaire
Part Number: 131858004
Color: white. Measures about 1-1/2 inches in diameter.
Do-It-Yourself Stories from Customers like You
Broken knob Dean P. • Superior , CO • April 27, 2015
This is an easy fix, but Appliance Parts Pros make finding the correct part easy. I looked at many sites to get a new knob, as I was tired of using pliers to start the dryer. The images on the grid are worth their weight in gold!
Read more
More
$58.26
- Compare At:
-
$69.33
- You Save:
-
$11.07
Genuine Whirlpool part
By: Whirlpool
Part Number: WPW10338554
This is the control knob assembly for the appliance's control shaft. It lets you select settings by turning the shaft without tools. A worn or cracked knob can slip, spin freely, or make it hard to set temperatures or cycles.
- Rotates the control shaft to adjust settings
- Replaces knobs that are cracked, stripped, or hard to turn
- Helps restore precise selection of temperatures and cycles
- Common symptoms include a loose knob, no response when turning, or difficulty gripping
What's included: One control knob assembly. Install notes:
- Disconnect power and allow hot surfaces to cool before service
- Pull the old knob straight off the shaft; avoid prying against the panel
- Align the new knob with the shaft flat and press firmly until seated
- Test operation through the full range of settings
Do-It-Yourself Stories from Customers like You
Selection nob was broken on dryer Anthony A. • Odessa , TX • August 24, 2015
Ordered a placement nob. Perfect match and fit..
Read more
More
$51.62
- Compare At:
-
$61.43
- You Save:
-
$9.81